Abstract:In this paper, numerical simulations and experiments were carried out to study the dynamic characteristics of thin‐walled carbon fiber‐reinforced polymer tubes with delamination damage. The effects of delamination size and delamination location on the dynamic characteristics of the structure were summarized. Thin‐walled carbon fiber‐reinforced‐polymer (CFRP) tubes are susceptible to damage, which impacts their dynamic characteristics. This paper investigates the influence of delamination damage on the dynamic properties of thin‐walled CFRP tubes through finite element simulation and experimental methods. A transversely isotropic principal model is employed to establish the geometric model. Delamination damage is induced using the cohesive zone model and the secondary stress criterion. Both circumferential and elliptical delamination cases are studied. The modal test is conducted using the hammer excitation method. It is observed that the finite element model aligns with the experimental results. It is discovered that the larger the delamination size, the lower the natural frequency for a given damage location. The location of the delamination within a single layer has minimal effect on the natural frequency. The natural frequency exhibits a symmetrical pattern of decreasing and then increasing as the delamination shifts from the sides toward the center layer. Positional information is discernible in the modal shape, which can be utilized for delamination detection and localization. Highlights The damage model is built by transversal isotropic equation and cohesive unit. Finite element model is built with various delamination sizes and locations for two cases. Modal tests are performed on CFRP tubes and obtained good accuracy. Effect of delamination size and location on dynamic parameters is discussed.

Large Deformation Delamination in Polymer Coatings: Discontinuous Galerkin/cohesive Zone Modeling

Applicability Evaluation of Damage Evolution Models in Simulating Repeated Low-Velocity Impact Behavior of Composite Laminates

A Lennard-Jones Potential Based Cohesive Zone Model and Its Application in Multiscale Damage Simulation of Graphene Reinforced Nanocomposites

An elastic-plastic cohesive zone model for metal-ceramic interfaces at finite deformations

Numerical study of thermomechanical delamination mechanisms in segmented high-temperature coatings

Finite Element Analysis of the Influence of Cohesive Law Parameters on the Multiple Delamination Behaviors of Composites under Compression

Numerical Investigation on the Loading-Delamination-unloading Behavior of Adhesive Joints

Numerical Simulation on the Interface Debonding in Solid Propellant under Large Deformation by a Cohesive Zone Model

Numerical and Experimental Analysis of Delamination in the T-Stiffener Integrated Composite Structure

A New Mechanism Based Cohesive Zone Model for Mode I Delamination Coupled with Fiber Bridging of Composite Laminates

Overcoming the cohesive zone limit in the modelling of composites delamination with TUBA cohesive elements

Composite Laminate Delamination Simulation and Experiment: A Review of Recent Development

Internal-interfacial cracking interaction: Combined phase-field and discontinuous Galerkin/cohesive zone modeling

A Cohesive-Zone-Based Contact Mechanics Analysis of Delamination in Homogeneous and Layered Half-Spaces Subjected to Normal and Shear Surface Tractions

Effect of delamination on the dynamic characteristics of thin‐walled carbon fiber‐reinforced polymer tube

The evolution of a transverse intra-ply crack coupled to delamination cracks

Application of a delamination model to laminated composite structures

Modelling Mullins effect induced by chain delamination and reattachment

Delamination prediction in composite laminates under low-velocity impact

Damage formation and evolution mechanisms in drilling CFRP with prefabricated delamination defects: Simulation and experimentation

An elastoplastic beam bond model for DEM simulation of deformable materials and breakage behaviors