Abstract:Electrode design and fabrication are of major importance for hydrogen evolution reaction applications, as far as high-efficiency and low-cost production of hydrogen are concerned. This paper reports on a titanium-nitride-ceramic-membrane electrode modified by MoS2 nanoflakes. Porous TiN-ceramic membranes were fabricated by phase-inversion tape-casting, followed by pressureless sintering. The as-prepared TiN membranes contained straight finger-like pores with an average diameter of 80 μm and smaller pores with an average diameter of 1–3 μm. Then, MoS2 nanoflakes were perpendicularly, densely, and uniformly grown on the surface of the TiN grains through the one-pot hydrothermal method. The optimized MoS2/TiN membrane electrode displayed a low overpotential of 113 mV at 10 mA cm–2, a Tafel slope of 78 mV dec–1, a small charge transfer resistance of 1.44 Ω, and a high double-layer capacitance of 504 mF cm–2. It also exhibited excellent stability with slight degradation after 80 h testing at an overpotential of 150 mV in 0.5 M H2SO4. The high conductivity of the TiN substrate, the similar chemical bonds, which favored the rapid electron transfer between MoS2 and TiN, the abundant exposed active sites of MoS2 nanoflakes, and the unique dual-pore structure resulted in the above superior electrocatalytic activity. The proposed successful utilization of conventional ceramic-membrane technology to prepare electrocatalysts based on membrane electrodes has potential for large-scale application in industrial hydrogen production.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsaem.1c00784?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsaem.1c00784</a>.Photographs of TiN green tapes and experimental device, SEM images of the finger-like layer and MoS2/TiN with various amounts of Mo and S precursors at the same ratio of Mo and S (1:4), XPS spectra of MoS2/TiN-1:2 and MoS2/TiN-1:8, cyclic voltammogram curves of pristine TiN, MoS2/TiN-1:2, MoS2/TiN-1:4, and MoS2/TiN-1:8, polarization curves of MoS2/TiN with various amounts of Mo and S precursors at the same ratio of Mo and S (1:4), comparison of electrocatalysts, and EIS data (<a class="ext-link" href="/doi/suppl/10.1021/acsaem.1c00784/suppl_file/ae1c00784_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Fast electrochemical reduction behavior and kinetics of nanoflower-like MoS<sub>2</sub>-modified titanium plate cathode to oxidized mercury

MoO3-adjusted Δ-Mno2 Nanosheet for Catalytic Oxidation of Hg0 to Hg2+

Electrochemical Reduction and Kinetic Analysis of Oxidized Mercury in Wastewater by Choosing Titanium Plate As Cathode

Modulation of MoS<sub>2</sub>@Ti electrode structure to improve electrode stability and enhance the efficiency of electrochemical reduction oxidized mercury

Modulation of MoS 2 @Ti electrode structure to improve electrode stability and enhance the efficiency of electrochemical reduction oxidized mercury

Modulation of MoS2@Ti electrode structure to improve electrode stability and enhance the efficiency of electrochemical reduction oxidized mercury

One-step Solvothermal Synthesis of MoS2@Ti Cathode for Electrochemical Reduction of Hg2+ and Predicting BP Neural Network Model

Integrated Dynamic and Steady State Method and Its Application on the Screening of MoS2 Nanosheet-Containing Adsorbents for Hg-0 Capture

Electrocatalytic reduction of Cr(VI) over heterophase MoS2 film electrode

Highly Efficient and Selective Hg(II) Removal from Water Using Multilayered Ti3C2Ox MXene Via Adsorption Coupled with Catalytic Reduction Mechanism

Highly Selective Electrocatalytic CuEDTA Reduction by MoS 2 Nanosheets for Efficient Pollutant Removal and Simultaneous Electric Power Output

Remarkable effect of the incorporation of titanium on the catalytic activity and SO2 poisoning resistance of magnetic Mn–Fe spinel for elemental mercury capture

Efficient reduction of Cr(VI) and elimination of total Cr with S-bridged Ni3S2/MoS2 nanowire electrode

MoS2 quantum dots based MoS2/HKUST-1 composites for the highly efficient catalytic oxidation of elementary mercury

Phase-mediated mercury removal from water using multilayered molybdenum disulfide: The key role of redox mechanism

Removing and recycling mercury from scrubbing solution produced in wet nonferrous metal smelting flue gas purification process

Electrocatalytic removal of persistent organic contaminants at molybdenum doped manganese oxide coated TiO2 nanotube-based anode

Electrochemical removal of gaseous elemental mercury in liquid phase with a novel foam titanium-based DSA anode

Electrospun metal oxide-TiO 2 nanofibers for elemental mercury removal from flue gas

Highly Efficient and Robust MoS 2 Nanoflake-Modified-TiN-Ceramic-Membrane Electrode for Electrocatalytic Hydrogen Evolution Reaction

Selective adsorption of mercury ion from water by a novel functionalized magnetic Ti based metal-organic framework composite