Abstract:The hot corrosion behaviour of plasma sprayed WC-CoCr coatings on AISI 316L steel substrate is studied in two corrosive salt environments namely 100% Na2SO4 and 75% Na2SO4+25%NaCl at 1000 °C. Also, on WC-CoCr coated AISI 316L steel substrate, a persistent Cr2O3 barrier scale is created employing pre-oxidation at 1200 °C for ten hours with the expectation that it would withstand hot corrosion in a Na2SO4 salt environment at 900 °C. X-ray diffraction (XRD), energy dispersive spectroscopy (EDS), electron micro probe analysis (EPMA) and scanning electron microscopy (SEM) are performed on samples to examine the pre oxidation and hot corrosion characteristics of plasma sprayed WC-CoCr coatings at elevated temperatures. The findings indicate that the presence of both salt environment affects the degradation process of WC-CoCr coatings. The coatings in 100% Na2SO4 and the mixture of 75% Na2SO4+25%NaCl has a weight change of 0.14 mg/cm2 and 0.33 mg/cm2, respectively, after hot corrosion at 1000 °C for 50 cycles. Each cycle includes 1 hour heating in furnace and 20 minutes cooling in ambient air. Corrosion kinetics using thermogravimetric method showed that non-pre-oxidized samples gained 52.5 % more weight and more severely affected by hot corrosion than pre-oxidized ones. During hot corrosion after 2 hours, there was relatively negligible corrosion, but after 4 and 8 hours, deposits of Na2WO4, WO3, Cr2O3 and CoSO4 were produced. Oxides were primarily composed of Cr2O3 and WO3. Cr2O3 and WO3 acted as barriers to the penetration and diffusion of corrosive elements through coatings, which contributed to the hot corrosion resistance in the corrosive area. The hot corrosion deterioration of WC-CoCr coatings may be effectively reduced by introducing pre oxidation. Slower reaction rate of pre oxidized Cr2O3 scale may operate as a barrier which separates hot corrosion by Na2SO4 salt.

Comparison on Long-Term Corrosion Performance of WC-CoCr and Al2O3-TiO2 Ceramic Coatings in Sulphide-Containing 3.5 Wt% NaCl Solution

Corrosion Behavior of Hvof Sprayed Hard Face Coatings in Alkaline-Sulfide Solution

Corrosion behaviors of Al2O3–20TiO2 and Cr2O3–3TiO2–5SiO2 coatings in both artificial seawater and high-pressure hydrogen sulfide seawater

Study on the Corrosion Resistance of Supersonic Plasma Spraying Al2O3 Thin Layer and SiO2 Sealer Alternately Deposited Coating

Corrosion Behavior in Boiling Dilute HCI Solution of Different Ceramic Coatings Fabricated by Plasma Spraying

Comparison on the immersion corrosion and electrochemical corrosion resistance of WC–Al 2 O 3 composites and WC–Co cemented carbide in NaCl solution

Corrosion Behavior of Al2O3-40TiO2 Coating Deposited on 20MnNiMo Steel via Atmospheric Plasma Spraying in Hydrogen Sulfide Seawater Stress Environments

Electrochemical Corrosion Behavior of Plasma Sprayed Al2o3-13%Tio2 Coatings in Aqueous Hydrochloric Acid Solution

Construction and Corrosion Behavior of Al2O3/Al2O3-Ca2SiO4 Double Ceramic Coating

The influence of sulphide on the ultrasonic cavitation erosion-corrosion behaviors of HVOF-sprayed WC-Cr 3 C 2 -Ni coating

Effect of Na2WO4 concentration on structure and corrosion resistance of micro-arc oxidation ceramic coatings on aluminum alloy used for seawater desalination

Effect of Chromate on the Electrochemical Behavior of Sintered Zn–Al Coating in Seawater

Studies on Corrosion Behavior of a Single-Crystal Superalloy and Its Sputtered Nanocrystalline Coatings with Solid NaCl Deposit in O2 + 38 Vol.% H2O Environment at 700 °C

Tribocorrosion behavior of HVOF sprayed WC-based cermet coatings in sodium chloride solution environment in relation to binder phases

Corrosion of the WC-12Co and enamel coatings in liquid Zn-55Al alloy at 640 °C

Comparisons of tribological and electrochemical properties of CrSiC and CrSiCN coatings in seawater

Hot corrosion behavior of CoCrNiAlY–YSZ–RSZ dual-ceramic thermal barrier coating with Al plating in molten sulfate mixture

Salt Spray Corrosion Test of Micro-Plasma Oxidation Ceramic Coatings on Ti Alloy

Corrosion Behavior of Chromium-Free Dacromet Coating in Seawater

Surface morphological studies on hot corrosion behaviour of pre-oxidized plasma sprayed WC-CoCr coating on AISI316L steel in Na 2 SO 4 /NaCl molten salt environment

Tribocorrosion characteristics of CrMoSiCN/Ag coatings on Ti6Al4V alloys in seawater