Abstract:Purpose Once an uneven substrate is aligned, traditional control theories and methods can be used on it, so aligning is of great significance for the development of wire and arc additive manufacturing (WAAM). This paper aims to propose a shape-driven control method for aligning a substrate with slopes to expand the application of WAAM. Design/methodology/approach A substrate with slopes must be aligned by depositing weld beads with slopes. First, considering the large height differences of slopes, multi-layer deposition is needed, and the number of layer of weld beads must be ascertained. Second, the change in the deposition rate is controlled as a ramp function to generate weld beads with slopes. Third, the variation of the deposition rate must be fine-tuned to compensate for the deviation between the actual and theoretical layer heights at the deposition of each layer. Finally, the parameters of the ramp functions at the deposition of each layer are determined through an optimization method. Findings First, to model the response function of layer height to deposition rate, the experiments are conducted with the deposition rate jumping from 4to 8mm/s and from 8 to 4mm/s. When the deposition rate jumps from 4 to 8mm/s and from 8to 4mm/s, the difference in the height of each layer decreases as the number of layer increases. Second, the variation of the deposition rate can be fine-tuned based on the deviation between the measured and theoretical layer heights because the variation of the deposition rate is proportional to the layer height when the initial and end deposition rates are near 4or 8mm/s, respectively. Third, the experimental results demonstrate that the proposed method is effective for single-layer aligning and aligning a substrate with one or more slopes. Originality/value The proposed method can expand the application of WAAM to an uneven substrate with slopes and lays the foundation for aligning tasks focused on uneven substrates with more complex shapes.

Height Control in GMA-AM Using External Wire As Controlling Variable

Feedback control of variable width in gas metal arc-based additive manufacturing

Adaptive Control of Deposited Height in GMAW-based Layer Additive Manufacturing

Study of the Mechanism of a Stable Deposited Height During GMAW-Based Additive Manufacturing

Impact of Process Parameters on Forming Quality and Deposition Efficiency of Unsupported Rods in Wire Arc Additive Manufacturing

Effects of deposition height stability of CuCrZr alloy based on arc voltage sensing: Influence of materials and energy saving on wire arc additive manufacturing

Arc voltage measurements for height control in pulsed arc additive manufacturing

Interlayer Closed-Loop Control of Forming Geometries for Wire and Arc Additive Manufacturing Based on Fuzzy-Logic Inference

Layer width control in robotic pulsed gas tungsten arc additive manufacturing through composite sensing of vision and arc

Height Stability Control of CuCrZr Alloy Based on Forming Characteristics and Droplet Transfer Behaviors in Wire Arc Additive Manufacturing

Robotic Wire Arc Additive Manufacturing with Variable Height Layers

Online Control of Deposited Geometry of Multi-layer Multi-bead Structure for Wire and Arc Additive Manufacturing

Research on GMAW Based Non-Supporting Thin-Wall Structure Manufacturing

Model Predictive Control Of Layer Width In Wire Arc Additive Manufacturing

Process Planning Strategy for Wire-Arc Additive Manufacturing: Thermal Behavior Considerations

Fused Plus Wire Arc Additive Manufacturing Materials and Energy Saving in Variable-Width Thin-Walled

Dynamic control of aluminum morphology by wire and arc additive manufacturing based on image feedback

Model-free Adaptive Iterative Learning Control of Melt Pool Width in Wire Arc Additive Manufacturing

Experimental investigation on improving the deposition rate of gas metal arc-based additive manufacturing by auxiliary wire feeding method

Shape-driven control of layer height in robotic wire and arc additive manufacturing

Monitoring process stability in GTA additive manufacturing based on vision sensing of arc length