Abstract:Introduction: In the past three decades, additive manufacturing (AM), also known as 3D printing, has emerged as a promising technology, which allows the manufacture of complex parts by adding material layer upon layer. In comparison, with other metal-based AM technologies, gas metal arc welding-based additive manufacturing (GMAW-based AM) presents a high deposition rate and has the potential for producing medium and large metal components. To validate the technological performance of such a manufacturing process, the internal quality of manufactured parts needs to be analyzed, particularly in the cases of manufacturing the parts working in a critical load-bearing condition. Therefore, this paper aims at investigating the internal quality (i.e., and mechanical properties) of components manufactured by the GMAW-based AM technology. Method: A gas metal arc welding robot was used to build a thin-walled component made of mild steel on a low-carbon substrate according to the AM principle. Thereafter, the specimens for observing and mechanical properties were extracted from the built thin-walled component. The of the specimen were observed by an optical microscope; the hardness was measured by a digital tester, and the tensile tests were carried out on a tensile test machine. Results: The results show that the GMAW-based AM-built thin-walled components possess an adequate that varies from the top to the bottom of the built component: structures with primary dendrites in the upper zone; granular structure of with small regions of at grain boundaries in the middle zone, and grains of in the lower zone. The hardness (ranged between 164±3.46 HV to 192±3.81 HV), yield strength (YS offset of 0.2% ranged from 340±2 to 349.67±1.53 ), and ultimate tensile strength (UTS ranged from 429±1 to 477±2 ) of the GMAW-based AM-built components were comparable to those of wrought mild steel. Conclusions: The results obtained in this study demonstrate that the GMAW-based AM-built components possess adequate and good mechanical properties for real applications. This allows us to confirm the feasibility of using a conventional gas metal arc welding robot for additive manufacturing or repairing/re-manufacturing of metal components.

Research on GMAW Based Non-Supporting Thin-Wall Structure Manufacturing

Design and Validation of 3D Self-Supporting Structures and Printing Paths for Multi-Axis Additive Manufacturing

Structural Behaviour and Design of Wire Arc Additively Manufactured Bolted Connections with Thick Plates

Research on Support-Free WAAM Based on Surface/interior Separation and Surface Segmentation

Heat Input Adjustment Process for Unsupported Aluminum Alloy Lattice Struts Continuous Forming by Wire Arc-Directed Energy Deposition

Study of the Mechanism of a Stable Deposited Height During GMAW-Based Additive Manufacturing

Path Planning of Complicated Hierarchical Thin-Wall Structures Using Multi-Material Additive Manufacturing Technology

A Multiaxis Tool Path Generation Approach for Thin Wall Structures Made with WAAM

Thermal Field Prediction for Welding Paths in Multi-Layer Gas Metal Arc Welding-Based Additive Manufacturing: A Machine Learning Approach

Manufacture of complex thin-walled metallic objects using weld-deposition based additive manufacturing

Spherical Path Planning for Multi Axis Support Free Additive Manufacturing of Truss Structures

Model for the Prediction of Deformations in the Manufacture of Thin-Walled Parts by Wire Arc Additive Manufacturing Technology

Fabrication of Metallic Parts with Overhanging Structures Using the Robotic Wire Arc Additive Manufacturing

A Trivariate T-spline Based Direct-Slicing Framework for Support-Free Additive Manufacturing

Layout and Geometry Optimization Design for 3D Printing of Self-Supporting Structures

3D‐Printing with Steel ‐ Additive Manufacturing Connections and Structures

A preliminary study on gas metal arc welding-based additive manufacturing of metal parts

Evaluation of thermal and geometric properties of martensitic stainless steel thin walls built by additive manufacturing cold metal transfer (CMT) processes

Multi-Robot Scan-n-Print for Wire Arc Additive Manufacturing

A Novel Additive Manufacturing Method for Spiral Parts

Bead Modelling and Implementation of Adaptive MAT Path in Wire and Arc Additive Manufacturing