Abstract:Wire and arc additive manufacturing (WAAM) has emerged as a highly promising technique for manufacturing large-scale steel structural elements. However, the distinct mechanical properties of WAAM steel could potentially lead to different performance of WAAM steel bolted connections compared to the traditional steel bolted connections. This study aims to investigate the material properties of WAAM steel and the structural behaviours of WAAM steel bolted connections, focusing on the effects of print layer orientation and connection plate geometrical dimensions. A total number of 24 WAAM steel coupon specimens with three different print layer orientations and 36 WAAM double-shear bolted connections with two print layer orientations and different geometric dimensions were designed, fabricated and tested under monotonic tension. These specimens were measured using a 3D laser scanner and Digital Image Correlation (DIC) was adopted to measure the structural response during testing. The impact of print layer orientations on WAAM material properties and the effects of WAAM material properties on bolted connections were analysed and discussed. The current design codes for traditional steel bolted connections were evaluated against the test results of WAAM steel bolted connections. The study found that the print layer orientations of WAAM steel plates initiated an anisotropic material property of the coupon specimens, demonstrated by the differences in ultimate tensile strength and strain of specimens with different print layer orientations. Five failure modes, including net section tension, shear-out, bearing, end-splitting, and block shear failure were observed for the bolted connections. The material anisotropy further affects the performance of the bolted connections, though in the same dimensions, 28% of the specimens presented different failure modes due to the different print layer orientations. The effectiveness of current steel design standards was compromised by inaccurate predictions of failure modes due to the distinct end-splitting failure mode and the effects of material anisotropy, though the predictions of the ultimate capacities of the WAAM lap shear specimens were relatively accurate.

3D‐Printing with Steel ‐ Additive Manufacturing Connections and Structures

3D‐Printing with Steel: Additive Manufacturing of a Bridge in situ

3D printing in steel construction with the automated Wire Arc Additive Manufacturing

Structural Behaviour and Design of Wire Arc Additively Manufactured Bolted Connections with Thick Plates

3D‐printing with steel on thin sheets for application in free form façade construction: welding process development and material properties

Experimental Study on Wire and Arc Additively Manufactured Steel Double-Shear Bolted Connections

Experimental Study on Mechanical Properties and Bond Behavior of Wire and Arc Additive Manufacturing Steel Bar

Research on GMAW Based Non-Supporting Thin-Wall Structure Manufacturing

Experimental Application of Robotic Wire-and-Arc Additive Manufacturing Technique for Strengthening the I-Beam Profiles

Metal additive manufacturing in structural engineering – review, advances, opportunities and outlook

Additive Manufacturing of Reinforced Concrete—Development of a 3D Printing Technology for Cementitious Composites with Metallic Reinforcement

Additive Manufacturing of Metal Materials for Construction Engineering: An Overview on Technologies and Applications

I-section steel columns strengthened by wire arc additive manufacturing - concept and experiments

Experiments and investigation of planar high-strength steel joints with additive manufacturing

Testing, analysis and design of wire and arc additively manufactured steel bolted connections

Arc Welding Processes for Additive Manufacturing: A Review

Weldability of Additively Manufactured Powder Bed Fusion 316L Stainless Steel Using Arc and Laser Welding

Selection of Parameters for Optimized WAAM Structures for Civil Engineering Applications

Metal 3D‐Printing for Repair of Steel Structures

Review of Wire Arc Additive Manufacturing for 3D Metal Printing