Abstract:As turbine inlet temperature gets higher and higher, thermal barrier coating (TBC) is more and more widely used in turbine blades. For turbine blades with TBC, it is of great significance to evaluate the temperature distribution of its substrate metal quickly and accurately, especially during the design stage. With different degrees of simplification such as whether to consider the change of the geometric size of the fluid domain by TBC and whether to consider the planar heat conduction in TBC, three different methods used in conjugate heat transfer (CHT) simulation to model the TBC of the turbine blades have been developed and widely used by researchers. However, little research has been conducted to investigate the influence of the three methods on the temperature distribution of turbine blade. To fill this gap, three geometric models were designed. They are a solid conduction model with a substrate metal layer and a TBC layer, a transonic turbine vane with internal cooling and TBC, and a plate cylindrical film hole cooling model with TBC. Different methods were used in these geometric models and their differences were carefully analyzed and discussed. The result shows that for the conduction model used in this paper, with the same TBC surface temperature distribution, the difference between the three methods is very small and can be ignored. For a transonic turbine vane with internal cooling, regarding the local maximum temperature of the substrate-TBC interface, the largest difference between the method in which TBC is considered as a thermal resistance or a virtual layer of cells and the method in which three-dimensional heat conduction equation of TBC is solved occurs at the trailing edge. The difference near the leading edge is below 2 K. When employed to the film cooling model, the difference of the laterally averaged temperature of the substrate-TBC interface can be 8 K which is mainly due to the change of the length to diameter ratio of the film cooling hole by TBC. If the substrate thickness is reduced by the thickness of TBC when three-dimensional heat conduction equation of TBC is solved, the temperature difference between the three methods will be quite limited.

Review: Radiation Temperature Measurement Methods for Engine Turbine Blades and Environment Influence

A Review Of Aero-Engine Turbine Blade Temperature Measurement

Advances in the application of non-contact temperature measurement technology for aero-engine blade.

Effective Spectral Emissivity of Gas Turbine Blades for Optical Pyrometry

A TEMPERATURE-GRADIENT CORRECTION METHOD FOR FILM COOLING EFFECTIVENESS MEASUREMENT USING ENDOSCOPE-BASED PSP TECHNIQUE

Research on Boundary Conditions of T Steam Turbine Blade by Finite Element Model Analysis

Temperature field measurement of turbine rotor blade leading edge based on infrared radiation pyrometer

Emissivity Measurement of Aero-engine Turbine Blade

Impact of High-Temperature Radiation on the Heat Transfer Characteristics of Film-Cooled Guide Vanes in Gas Turbines

Effect of Radiation on Heat Transfer Inside Aeroengine Compressor Rotors

Analysis of Radiation-Convection Coupled Effects on the Turbine Vane with Different Gas Compositions

Fiber Optic Array Temperature Field Measurement System for High-Temperature Turbine Blades

Recent Progress in Service Induced Degradation of Turbine Blades of Aeroengine Due to Overheating

Dynamic Measurement of Temperature Field and Deformation in Hydraulic Turbine Blade at Cooling Stage of Heat Treatment

Panoramic Scanning Optical Pyrometer for the Temperature Field Measurement of Turbine Components

Effect Of Radiative Heat Transfer Factor On The Temperature Distribution Of A First Stage Vane

Heavy-duty gas turbine 3D blade modelling and flow field analysis

On the Heat-Transfer Effect of Spraying Speed During the Plasma Spraying on Turbine Blade

Comparative Study on Different Methods for Prediction of Thermal Insulation Performance of Thermal Barrier Coating Used on Turbine Blades

Experimental Evidence of Temperature Ratio Effect on Turbine Blade Tip Heat Transfer

A Modified Analytical Model to Calculate Temperature Distribution of Gas Turbine Blade and the Cooling Air Required