Abstract:The present study considers spatially-resolved surface heat transfer coefficients and adiabatic wall temperatures on a turbine blade tip in a linear cascade under transonic conditions. Six different measurement and processing techniques are considered and compared, including transient infrared thermography and thin-film heat flux gauges. Three methods use the same experimental setup, using a heater mesh to provide a near-instantaneous step-change in mainstream temperature, employing an infrared camera to measure surface temperature. The three methods use the same data but different processing techniques to determine the heat transfer coefficients and adiabatic wall temperatures. Two methods use different processing techniques to reconstruct heat flux from the temperature time trace measured. A plot of the heat flux versus temperature is used to determine the heat transfer coefficients and adiabatic wall temperatures. The third uses the classical solution to the 1-D non-steady Fourier equation to determine heat transfer coefficients and adiabatic wall temperatures. A fourth method uses regression analysis to calculate detailed heat transfer coefficients for a quasi-steady state condition using a thin-foil heater on the tip surface. The fifth method uses the infrared camera to measure the adiabatic wall temperature surface distribution of a blade tip after a quasi-steady state condition is present. Finally, the sixth method employs thin-film gauges to measure surface temperature histories at four discreet blade tip locations. With this approach, heat flux reconstruction is used to calculate the transient heat transfer coefficients and adiabatic wall temperatures. Overall, the present study shows that the infrared thermography technique with heat flux reconstruction using the Impulse method, is the most accurate and reliable method to obtain detailed, spatially-resolved heat transfer coefficients and adiabatic wall temperatures on a turbine blade tip in a linear cascade.

Emissivity Measurement of Aero-engine Turbine Blade

Turbine Blade Three-Wavelength Radiation Temperature Measurement Method Based on Reflection Error Correction

Effective Spectral Emissivity of Gas Turbine Blades for Optical Pyrometry

A Review Of Aero-Engine Turbine Blade Temperature Measurement

Temperature field measurement of turbine rotor blade leading edge based on infrared radiation pyrometer

Thermal Emissivity Measurement with Two-temperature Method

Multispectral Radiometric Temperature Measurement Algorithm for Turbine Blades Based on Moving Narrow-Band Spectral Windows.

Advances in application of contact temperature measurement technology for aero-engine blade

Review: Radiation Temperature Measurement Methods for Engine Turbine Blades and Environment Influence

Comparison of Heat Transfer Measurement Techniques on a Transonic Turbine Blade Tip

Advances in the application of non-contact temperature measurement technology for aero-engine blade.

Three-dimensional temperature reconstruction strategy for turbine blades using infrared thermography at simulated-engine conditions

Fiber Optic Array Temperature Field Measurement System for High-Temperature Turbine Blades

Panoramic Scanning Optical Pyrometer for the Temperature Field Measurement of Turbine Components

Service Temperature Measurement and Thermal Insulation Mechanism of Thermal Barrier Coatings

Study on Method for Measuring Coating Emissivity by Applying Active Irradiation Based on Infrared Thermal Imager

TIME-RESOLVED HEAT TRANSFER MEASUREMENTS ON TURBINE OUTER ENDWALL IN A BLOWN-DOWN TRANSIENT TEST FACILITY

Infrared thermography with non-uniform heat flux boundary conditions on the rotor endwall of an axial turbine

Field Measurement Methods for Thermal Infrared Spectral Emissivity of Terrestrial Surface Materials

Research on the technique of accurately measuring temperature with infrared thermal imagers

Measurements of Temperature and Emissivity Distributions on a High-Temperature Surface Using an Auxiliary Light Source Method