Abstract:The development of sensitive fiber-optic accelerometers is a subject of continuing interest. To acquire high resolution, Michelson phase interferometric techniques are widely adopted. Among the variety structures, the compliant cylinder approach is particularly attractive due to its high sensitivity that is defined as the induced phase shift per applied acceleration. While the two arms of Michelson interferometer should be at the same optical path, it is inconvenient to adjust the two arms' length to equal, also the polarization instability and phase random drift will cause a signal decline. To overcome these limitations, a novel optical fiber accelerometer based on differential interferometric techniques is proposed and investigated. The interferometer is a Sagnac-like white light interferometer, which means the bandwidth of laser spectrum can be as wide as tens nanometers. This interferometer was firstly reported by Levin in 1990s. Lights are divided to two paths before entering the coupler. To induce time difference, one passes through a delay arm and another goes a direct arm. After modulated by the sensing component, they reflect to opposite arm. The sensing part is formed by a seismic mass that is held to only one compliant cylinder, where the single-mode optical fiber is wrapped tightly. When sticking to vibrations, the cylinder compresses or stretches as a spring. The corresponding changes in cylinder circumference lead to strain in the sensing fibers, which is detected as an optical phase shift by the interferometer. The lights from two arms reach the vibration source at different time, sensing a different accelerate speed; produce a different optic path difference. Integrating the dissimilarity of the accelerated speed by time can obtain the total acceleration graph. A shaker's vibration has been tested by the proposed accelerometer referring to a standard piezoelectric accelerometer. A 99.8% linearity of the optical phase shift to the ground acceleration is achieved. The acceleration sensitivity is 300 rad/g. It proves to have a simple structure, good practice, reliable measurement and stable performance.

A Novel Optical Accelerometer Based on Slant-Ended Fiber

Monolithic Integrated Cavity Optomechanical Accelerometer Based on Push-Pull Photonic Crystal Zipper Cavity

Single Chip-Based Nano-Optomechanical Accelerometer Based on Subwavelength Grating Pair and Rotated Serpentine Springs

A Novel Scheme Design of a High-G Optical NEMS Accelerometer Based on a Single Chip Grating with Proper Sensitivity and Large Bandwidth

Optical Acceleration Measurement Method with Large Non-ambiguity Range and High Resolution Via Synthetic Wavelength and Single Wavelength Superheterodyne Interferometry

Optical Accelerometer Based On Grating Interferometer With Phase Modulation Technique

A Novel Differential Optical Fiber Accelerometer

Silicon micromechanical accelerometer using an optical fiber

Micro-Machined Optical Fiber Side-Cantilevers for Acceleration Measurement

Low-Cost Fiber Optic Cantilever Accelerometer with a Spherical Tip Based on Gaussian Beam Focusing

Fiber-Optic Accelerometer Based on A Modal Interferometer Using A Thin-Core Fiber

A Mzi Based Integrated Optical Accelerometer

A Vector Accelerometer Based on Optical Fiber Cantilever with Hybrid Gratings

Compact Fiber Optic Accelerometer

Novel optical accelerometer based on Fresnel diffractive micro lens

A New Fiber Optic Accelerometer Based on Fiber Bragg Grating

Miniature Tri-Axis Accelerometer Based on Fiber Optic Fabry-Pérot Interferometer.

Highly sensitive fiber-optic accelerometer using a micro suspended-core fiber.

Design Of A Novel Optical Acceleration Sensor

A Novel and Miniaturized FPI Accelerometer Based on a Spherical Air Cavity at Fiber End

A Fiber Optic Accelerometer with High Sensitivity Based on Two-End Fixed Beam