Abstract:Multimode fibers are attractive for high-power lasers if transverse modes are efficiently controlled. Here, a dielectric thin-film mirror (R~20%) is micro-fabricated on the central area of the end face of a 1 km multimode 100/140 µm graded-index fiber and tested as the output mirror of a Raman laser with highly multimode (M2~34) 940 nm diode pumping. In the cavity with highly reflective input FBG, Raman lasing of the Stokes wave at 976 nm starts at the threshold pump power of ~80 W. Mode-selective properties of mirrors with various diameters were tested experimentally and compared with calculations in COMSOL, with the optimum diameter found to be around 12 µm. The measured Raman laser output beam at 976 nm has a quality factor of M2~2 near the threshold, which confirms a rather good selection of the fundamental transverse mode. The power scaling capabilities, together with a more detailed characterization of the output beam's spatial profile, spectrum, and their stability, are performed. An approximately 35 W output power with an approximately 60% slope efficiency and a narrow spectrum has been demonstrated at the expense of a slight worsening of beam quality to M2~3 without any sign of mirror degradation at the achieved intensity of >30 MW/cm2. Further power scaling of such lasers as well as the application of the proposed technique in high-power fiber lasers are discussed.

Comparison of Multimode GRIN-fiber Raman Lasers with FBG and Random DFB Cavity

Random Raman Lasing in Diode-Pumped Multi-Mode Graded-Index Fiber with Femtosecond Laser-Inscribed Random Refractive Index Structures of Various Shapes

Random Raman fiber laser based on a twin-core fiber with FBGs inscribed by femtosecond radiation

High Order Cascaded Raman Random Fiber Laser with High Spectral Purity

Influence of Bragg Reflection of Chirped Tilted Fiber Bragg Grating on Raman Suppression in High-Power Tandem Pumping Fiber Amplifiers.

Ultrafast Raman fiber Laser with Random Distributed Feedback

Sub-kHz high-order mode Brillouin random fiber laser based on long-period fiber grating and distributed Rayleigh scattering in a half-open linear cavity

Raman Lasing and Transverse Mode Selection in a Multimode Graded-Index Fiber with a Thin-Film Mirror on Its End Face

A half-open cavity random fiber laser based on a single-mode fiber and fiber Bragg grating

Ultrafast Raman fiber laser: a review and prospect

High-Power Random Raman Fiber Laser With an Ultrashort Random Fiber Grating

More Than 200 W Random Raman Fiber Laser with Ultra-Short Cavity Length Based on Phosphosilicate Fiber

Two-Frequency Brillouin Fiber Laser Based on Bragg Grating Fabry-Perot Cavity

Multi-wavelength random fiber laser based on a tilted parallel inscribed apodized fiber Bragg grating array

Towards optimal conversion efficiency of Brillouin random fiber lasers in a half-open linear cavity

Characteristics of Fibre Bragg Gratings and Influences on High-Power Raman Fibre Lasers

Robust femtosecond-written chirped and tilted fiber Bragg gratings for Raman filtering in multi-kW fiber lasers

Random Laser Based on Ytterbium-Doped Fiber with a Bragg Grating Array as the Source of Continuous-Wave 976 nm Wavelength Radiation

Short 17-cm DBR Raman Fiber Laser With a Narrow Spectrum

Optimized femtosecond laser direct-written fiber Bragg gratings with high reflectivity and low loss