Abstract:In wind tunnel tests, the low-frequency and large-amplitude vibration of the cantilever sting result in poor test data in pitch plane and yaw plane, more seriously, even threatens the safety of wind tunnel tests. To ensure the test data quality, a multidimensional vibration suppression method is proposed to withstand the vibration from any direction, which is based on a system with stackable piezoelectric actuators and velocity feedback employing accelerometers. Firstly, the motion equation of the cantilever sting system is obtained by Hamilton's principle with the assumed mode method. Then, the multidimensional active control mechanism is qualitatively analyzed and a negative velocity feedback control algorithm combined with a root mean square (RMS) evaluation method is introduced to realize active mass and active damping effect, meanwhile, a weight modification method is performed to determine the sequence number of the stacked piezoelectric actuators and the weight of control voltages in real time. Finally, a multidimensional vibration suppression system was established and verification experiments were carried out in lab and a transonic wind tunnel. The results of lab experiments indicate that the damping ratio of the system is improved more than 4.3 times and the spectrum analyses show reductions of more than 23 dB. In addition, wind tunnel test results have shown that for the working conditions (alpha = -4 similar to 10 degrees with gamma = 0 degrees or alpha = -4 similar to 10 degrees with gamma = 45 degrees) respectively at 0.6 Ma and 0.7 Ma, the remainder vibration is less than 1.53 g, which proves that the multidimensional vibration suppression method has the ability to resist vibration from any direction to ensure the smooth process of wind tunnel tests.

Low frequency vibration suppression of a moderate thick cabin structure by multiple piezoelectric patches shunted with RL-double negative capacitance circuits

Active Radiation Noise Control of Airplane's Cabin Using Piezoelectric Elements

Vibration Suppression of a Hull Section by Shunted Piezoelectric Patches: Experiments

Sound Insulation Performance of Composite Double Sandwich Panels with Periodic Arrays of Shunted Piezoelectric Patches

Frequency Adaptive Piezoelectric Shunt Damping System for Vibration Suppression of Precision Mechanism

Study on broad flexural wave bandgaps of piezoelectric phononic crystal plates for the vibration and noise attenuation

Passive vibration control of subsonic thin plate via nonlinear capacitance and negative capacitance coupled piezoelectric shunt damping

Vibration Suppression on the Composite Laminated Plates Subjected to Aerodynamic and Harmonic Excitations Based on the Nonlinear Piezoelectric Shunt Damping

MIMO Multi-Frequency Active Vibration Control for Aircraft Panel Structure Using Piezoelectric Actuators

Piezoelectric Active Disturbance Rejection Control for Flow-Induced Vibration of the Wind Tunnel Test Models

Vibration Reduction of Car Body Based on 2D Dual-Base Locally Resonant Phononic Crystal

Design of electromechanical coupled metamaterial plates for low-frequency vibration control in aircraft structures

Active Vibration Control of Piezoelectric Bonded Smart Structures Using PID Algorithm

Vibration Suppression Of A Hard Disk Driver Actuator Arm Using Piezoelectric Shunt Damping With A Topology-Optimized Pzt Transducer

Active suppression of panel flutter with piezoelectric actuators using eigenvector orientation method

Multidimensional Vibration Suppression Method With Piezoelectric Control For Wind Tunnel Models

Integrated Vibration Control for the Apparatus Cabin of Cz-3a Launch Vehicle

Simulation and Experimental Study on Vibration and Sound Radiation Control with Piezoelectric Actuators

Vibration Attenuations Induced by Periodic Arrays of Piezoelectric Patches Connected by Enhanced Resonant Shunting Circuits

Tunable Shunting Periodic Acoustic Black Holes for Low-Frequency and Broadband Vibration Suppression

Nonlinear Dynamic and Piezoelectric Ply Control Strategies Investigations on Laminated Flexible Spacecraft