Abstract:Piezoelectric shunt damping techniques using linear circuits (e.g. resistive-inductive) and switching circuits (e.g. synchronized switch on inductor) have been extremely well studied for suppressing resonant vibrations in flexible structures. Both analog circuits and synthetic impedance circuits with digital control have been explored for linear concepts. In a parallel body of work, from the domain of mechanical methods of vibration attenuation, it is also known that leveraging nonlinearities (e.g. stiffness nonlinearity) can enhance the frequency bandwidth and offer amplitude-dependent suppression over a range of frequencies. However, the existing piezoelectric shunt damping techniques have been mostly limited to linear or switching nonlinear circuits, with the exception of a few nonlinear capacitance efforts. This work aims to introduce cubic inductance to emulate Duffing-type hardening nonlinearity in the shunt circuit with precise digital programming and tuning capability. Experiments are performed on a piezoelectric bimorph cantilever under base excitation for concept demonstration and model validation. First, linear frequency response functions of the cantilever are obtained for the short- and open-circuit conditions, and for linear resistive-inductive synthetic shunt damping, to confirm the standard linear behavior and electromechanical model parameters. Then, cubic inductance is introduced to the circuit and nonlinear experiments (up- and down-frequency sweep) are conducted. Cantilever tip to base motion transmissibility frequency response is measured along with piezoelectric voltage to base motion counterpart for a range of base excitation amplitudes. The distortion of the frequency response curves with increased base acceleration levels is observed. The nonlinear cubic coefficient is then varied to alter the manifestation of nonlinear frequency response at a given base excitation level, demonstrating the ease of tuning and triggering the nonlinear behavior on demand by means of the digitally-controlled synthetic impedance shunt. Nonlinear electromechanical model simulations are also validated against the experiments, yielding a very good agreement.

Frequency Adaptive Piezoelectric Shunt Damping System for Vibration Suppression of Precision Mechanism

Vibration Suppression on the Composite Laminated Plates Subjected to Aerodynamic and Harmonic Excitations Based on the Nonlinear Piezoelectric Shunt Damping

Broadening the frequency response of a Duffing-type piezoelectric shunt by means of negative capacitance

Vibration Control with Optimized Piezoelectric Shunt Damping System Using Pole Placement

Adaptive vibration suppression system: An iterative control law for a piezoelectric actuator shunted by a negative capacitor

Enhanced Semi-active piezoelectric vibration control method with shunt circuit by energy dissipations switching

A nonlinear piezoelectric shunt absorber with tunable piecewise linear negative capacitance

Multimode piezoelectric shunt damping of thin plates with arrays of separately shunted patches, method, and experimental validation

Vibration Suppression of Blisk Using Piezoelectric Shunt Damping with Negative Capacitance

Duffing-type digitally programmable nonlinear synthetic inductance for piezoelectric structures

Vibration Suppression of a Hull Section by Shunted Piezoelectric Patches: Experiments

Modeling Analysis and Tuning of Shunt Piezoelectric Damping Controller for Structural Vibration

Design of inductors with high inductance values for resonant piezoelectric damping

Note: Self-Sensing Based on Charge Control Improves the Performance of Active Damping Using Piezoelements

Semi-active Control of Piezoelectric Coating׳s Underwater Sound Absorption by Combining Design of the Shunt Impedances

Experiments on Active Precision Isolation with A Smart Conical Adapter

Stochastic Vibration Suppression of Composite Laminated Plates Based on Negative Capacitance Piezoelectric Shunt Damping

Frequency tuning and automatic frequency tracking of shunted piezoelectric transducers

Low frequency vibration suppression of a moderate thick cabin structure by multiple piezoelectric patches shunted with RL-double negative capacitance circuits

Active micro-vibration isolation system for adaptive vibration suppression tests using piezoelectric stack actuator

Piezoelectric Shunt Damping Model of Beam