Abstract:Focusing on the bending wave characteristic of plate-shell structures, this paper derives the complex band curve of piezoelectric phononic crystal based on the equilibrium differential equation in the plane stress state using COMSOL PDE 6.2. To ascertain the computational model's accuracy, the computed complex band curve is then cross-validated against real band curves obtained through coupling simulations. Utilizing this model, this paper investigates the impact of structural and electrical parameters on the bandgap range and the attenuation coefficient in the bandgap. Results indicate that the larger surface areas of the piezoelectric sheet correspond to lower center bands in the bandgap, while increased thickness widens the attenuation coefficient range with increased peak values. Furthermore, the influence of inductance on the bandgap conforms to the variation law of the electrical LC resonance frequency, and increased resistance widens the attenuation coefficient range albeit with decreased peak values. The incorporation of negative capacitance significantly expands the low-frequency bandgap range. Visualized through vibration transfer simulations, the vibration-damping ability of the piezoelectric phononic crystal is demonstrated. Experimentally, this paper finds that two propagation modes of bending waves (symmetric and anti-symmetric) result in variable voltage amplitudes, and the average vibration of the system decreases by 4-5 dB within the range of 1710-1990 Hz. The comparison between experimental and model-generated data confirms the accuracy of the attenuation coefficient calculation model. This convergence between experimental and computational results emphasizes the validity and usefulness of the proposed model, and this paper provides theoretical support for the application of piezoelectric phononic crystals in the field of plate-shell vibration reduction.

Study on broad flexural wave bandgaps of piezoelectric phononic crystal plates for the vibration and noise attenuation

Research on Tunable Bandgap Characteristics of the Phononic Crystal Duct with Piezoelectric Thin Plates for the Broad Noise Reduction

A locally-resonant phononic crystal for low-frequency vibration control of vehicles

Research on Multi-Band Structural Noise Reduction of Vehicle Body Based on Two-Degree-of-freedom Locally Resonant Phononic Crystal

Vibration Reduction of Car Body Based on 2D Dual-Base Locally Resonant Phononic Crystal

Acoustic Attenuation Characteristics of the Muffler Phononic Crystal with Hybrid Resonators

Experimental Design and Adaptive Modulation of Piezoelectric Cantilever Phononic Crystals for Vibration Attenuation in Vehicle Subframes

Application Research of Phononic Crystals to Reduce Body Ceiling's Vibration

An Investigation on Interior Noise Reduction Using 2D Locally Resonant Phononic Crystal with Point Defect on Car Ceiling

Interior Noise Reduction Scheme Based on Phonon Crystal and Its Defect Characteristics

Tuning Flexural Elastic Wave Propagation in Electroactive Phononic Crystals

Flexural Vibration Band Gaps in a Double-Side Phononic Crystal Plate

Study on the vibration attenuation property of one finite and hybrid piezoelectric phononic crystal beam

A Novel Hybrid Composite Phononic Crystal Plate with Multiple Vibration Band Gaps at Low Frequencies

Acoustic and Aerodynamic Performances of One Phononic Crystal Duct with Periodic Mufflers

Research on Targeted Modulation of Elastic Wave Bandgap in Cantilever-Structured Piezoelectric Phononic Crystals

Vibrational loss analysis of a new type of phononic crystal with a tungsten block embedded inside a rubber matrix

Research on Flexural Wave Band Gap of A Thin Circular Plate of Piezoelectric Radial Phononic Crystals

Analysis of Flexural and Torsional Vibration Band Gaps in Phononic Crystal Beam

Bandgap Calculation and Experimental Analysis of Piezoelectric Phononic Crystals Based on Partial Differential Equations

Flexural vibration band gaps in advanced composite grid structures using finite element method