Abstract:The use of multiple synchronized outputs from an arbitrary waveform generator (AWG) provides the opportunity to perform EPR experiments differently than by conventional EPR. We report a method for reconstructing the quadrature EPR spectrum from periodic signals that are generated with sinusoidal magnetic field modulation such as continuous wave (CW), multiharmonic, or rapid scan experiments. The signal is down-converted to an intermediate frequency (IF) that is less than the field scan or field modulation frequency and then digitized in a single channel. This method permits use of a high-pass analog filter before digitization to remove the strong non-EPR signal at the IF, that might otherwise overwhelm the digitizer. The IF is the difference between two synchronized X-band outputs from a Tektronix AWG 70002A, one of which is for excitation and the other is the reference for down-conversion. To permit signal averaging, timing was selected to give an exact integer number of full cycles for each frequency. In the experiments reported here the IF was 5kHz and the scan frequency was 40kHz. To produce sinusoidal rapid scans with a scan frequency eight times IF, a third synchronized output generated a square wave that was converted to a sine wave. The timing of the data acquisition with a Bruker SpecJet II was synchronized by an external clock signal from the AWG. The baseband quadrature signal in the frequency domain was reconstructed. This approach has the advantages that (i) the non-EPR response at the carrier frequency is eliminated, (ii) both real and imaginary EPR signals are reconstructed from a single physical channel to produce an ideal quadrature signal, and (iii) signal bandwidth does not increase relative to baseband detection. Spectra were obtained by deconvolution of the reconstructed signals for solid BDPA (1,3-bisdiphenylene-2-phenylallyl) in air, 0.2mM trityl OX63 in water, 15N perdeuterated tempone, and a nitroxide with a 0.5G partially-resolved proton hyperfine splitting.

Design and Performance of a New Multifunction X-band EPR Spectrometer

Design and Implementation of Integrated Dual-Mode Pulse and Continuous-Wave Electron Paramagnetic Resonance Spectrometers

A Time-Resolved Three-Channel Soft X-ray Spectrometer

A New Design of Resonant Cavity for the W-band EPR spectrometer

A Design of Resonant Cavity with an Improved Coupling-Adjusting Mechanism for the W-band EPR Spectrometer

Design of Rectangular Resonators and Planar Microresonators for X-band Pulsed EPR Spectrometer

Microwave Bridge in a DNP-EPR Multifunctional Spectrometer:Design and Implementation

Broadband Electron Paramagnetic Resonance Spectrometer from 1 to 15 GHz Using Metallic Coplanar Waveguide.

A New Small Magnetic Modulation Microwave EPR Spectrometer

Educational microwave EPR spectrometer

The CW-EPR Capabilities of a Dual DNP/EPR Spectrometer Operating at 14 and 7 T

An X-band Pulsed Electron Paramagnetic Resonance Spectrometer with Time Resolution Improved by a Field-Programmable-gate-array Based Pulse Generator.

Maximizing the Applicability of Continuous Wave (CW) Electron Paramagnetic Resonance (EPR): What More Can We Do after a Century?

Research Progress of EPR Spectrometer Under High Frequency and High Field

A continuous-wave and pulsed X-band electron spin resonance spectrometer operating in ultra-high vacuum for the study of low dimensional spin ensembles

Concept Design of Ultrafast Charge Exchange Recombination Spectroscopy on EAST Tokamak

Broadband ESR Spectroscopy with a Tunable Interferometer

A New Μ-Xrf Spectrometer

Digitally generated excitation and near-baseband quadrature detection of rapid scan EPR signals

Precision Mechanical Design Of An Ultrahigh-Resolution Inelastic X-Ray Scattering Spectrometer System With Cdfdw Optics At The Aps

Supersonic-jet cryogenic-resonator coaxially oriented beam-resonator arrangement Fourier transform microwave spectrometer