Abstract:The use of multiple synchronized outputs from an arbitrary waveform generator (AWG) provides the opportunity to perform EPR experiments differently than by conventional EPR. We report a method for reconstructing the quadrature EPR spectrum from periodic signals that are generated with sinusoidal magnetic field modulation such as continuous wave (CW), multiharmonic, or rapid scan experiments. The signal is down-converted to an intermediate frequency (IF) that is less than the field scan or field modulation frequency and then digitized in a single channel. This method permits use of a high-pass analog filter before digitization to remove the strong non-EPR signal at the IF, that might otherwise overwhelm the digitizer. The IF is the difference between two synchronized X-band outputs from a Tektronix AWG 70002A, one of which is for excitation and the other is the reference for down-conversion. To permit signal averaging, timing was selected to give an exact integer number of full cycles for each frequency. In the experiments reported here the IF was 5kHz and the scan frequency was 40kHz. To produce sinusoidal rapid scans with a scan frequency eight times IF, a third synchronized output generated a square wave that was converted to a sine wave. The timing of the data acquisition with a Bruker SpecJet II was synchronized by an external clock signal from the AWG. The baseband quadrature signal in the frequency domain was reconstructed. This approach has the advantages that (i) the non-EPR response at the carrier frequency is eliminated, (ii) both real and imaginary EPR signals are reconstructed from a single physical channel to produce an ideal quadrature signal, and (iii) signal bandwidth does not increase relative to baseband detection. Spectra were obtained by deconvolution of the reconstructed signals for solid BDPA (1,3-bisdiphenylene-2-phenylallyl) in air, 0.2mM trityl OX63 in water, 15N perdeuterated tempone, and a nitroxide with a 0.5G partially-resolved proton hyperfine splitting.

Design and Implementation of Integrated Dual-Mode Pulse and Continuous-Wave Electron Paramagnetic Resonance Spectrometers

Compact Electron Paramagnetic Resonance on a Chip Spectrometer Using a Single Sided Permanent Magnet

Frequency multiplexing enables parallel multi-sample EPR

An X-band Pulsed Electron Paramagnetic Resonance Spectrometer with Time Resolution Improved by a Field-Programmable-gate-array Based Pulse Generator.

Broadband Electron Paramagnetic Resonance Spectrometer from 1 to 15 GHz Using Metallic Coplanar Waveguide.

Electrically Detected Magnetic Resonance on a Chip (EDMRoC) for Analysis of Thin-Film Silicon Photovoltaics

Design of an Electrochemical Cell for Continuous Wave EPR Measurements of Radical Ions

An Inexpensive, Configurable Two-Tone Electron Spin Resonance Spectrometer

Integrated Microring Spectrometer with In-Hardware Compressed Sensing to Break the Resolution-Bandwidth Limit for General Continuous Spectrum Analysis

Rapid scan EPR: Automated digital resonator control for low-latency data acquisition

Design and implementation of an FPGA-based timing pulse programmer for pulsed-electron paramagnetic resonance applications

A Novel Raman Spectrum Detection System Based on an Integrated Optical Biosensor

Scalable On‐Chip Microdisk Resonator Spectrometer

A Novel Multi-sinusoidal PWM Excitation for Online Battery Impedance Spectroscopy Identification and Implementation by Reconfigurable Battery Systems

Electrically Detected Magnetic Resonance Modeling and Fitting: An Equivalent Circuit Approach

Microwave field mapping for EPR-on-a-chip experiments

X-band single chip integrated pulsed electron spin resonance microsystem

The CW-EPR Capabilities of a Dual DNP/EPR Spectrometer Operating at 14 and 7 T

High-frequency high-power DNP/EPR spectrometer operating at 7 T magnetic field

Time-resolved Electron Paramagnetic Resonance Spectrometer Based on Ultrawide Single-Sideband Phase-Sensitive Detection.

Digitally generated excitation and near-baseband quadrature detection of rapid scan EPR signals