Abstract:The use of multiple synchronized outputs from an arbitrary waveform generator (AWG) provides the opportunity to perform EPR experiments differently than by conventional EPR. We report a method for reconstructing the quadrature EPR spectrum from periodic signals that are generated with sinusoidal magnetic field modulation such as continuous wave (CW), multiharmonic, or rapid scan experiments. The signal is down-converted to an intermediate frequency (IF) that is less than the field scan or field modulation frequency and then digitized in a single channel. This method permits use of a high-pass analog filter before digitization to remove the strong non-EPR signal at the IF, that might otherwise overwhelm the digitizer. The IF is the difference between two synchronized X-band outputs from a Tektronix AWG 70002A, one of which is for excitation and the other is the reference for down-conversion. To permit signal averaging, timing was selected to give an exact integer number of full cycles for each frequency. In the experiments reported here the IF was 5kHz and the scan frequency was 40kHz. To produce sinusoidal rapid scans with a scan frequency eight times IF, a third synchronized output generated a square wave that was converted to a sine wave. The timing of the data acquisition with a Bruker SpecJet II was synchronized by an external clock signal from the AWG. The baseband quadrature signal in the frequency domain was reconstructed. This approach has the advantages that (i) the non-EPR response at the carrier frequency is eliminated, (ii) both real and imaginary EPR signals are reconstructed from a single physical channel to produce an ideal quadrature signal, and (iii) signal bandwidth does not increase relative to baseband detection. Spectra were obtained by deconvolution of the reconstructed signals for solid BDPA (1,3-bisdiphenylene-2-phenylallyl) in air, 0.2mM trityl OX63 in water, 15N perdeuterated tempone, and a nitroxide with a 0.5G partially-resolved proton hyperfine splitting.

Rapid scan EPR: Automated digital resonator control for low-latency data acquisition

A Broadband NMR Magnetometer System with Field Searching and Automatic Tuning Function

Development of an L-band rapid scan EPR digital console

Rapid Scan EPR imaging as a Tool for Magnetic Field Mapping

Surface dielectric resonator for in vivo EPR measurements

Design and Implementation of Integrated Dual-Mode Pulse and Continuous-Wave Electron Paramagnetic Resonance Spectrometers

Digitally generated excitation and near-baseband quadrature detection of rapid scan EPR signals

The EDMR Microscope - Combining Conductive Atomic Force Microscopy with Electrically Detected Magnetic Resonance

Rapid Electromagnetic Induction Imaging with an Optically Raster-Scanned Atomic Magnetometer

Imaging characterization of the rapid adiabatic passage in a source-rotatable, crossed-beam scattering experiment

Frequency multiplexing enables parallel multi-sample EPR

Resonant Scanning Design and Control for Fast Spatial Sampling

Digital detection and processing of multiple quadrature harmonics for EPR spectroscopy

High-Speed Stimulated Raman Scattering Microscopy Using Inertia-Free AOD Scanning

Hand‐held electron spin resonance scanner for subcutaneous oximetry using OxyChip

Rapid Scan White Light Two-dimensional Electronic Spectroscopy with 100 kHz Shot-to-Shot Detection

Compact Electron Paramagnetic Resonance on a Chip Spectrometer Using a Single Sided Permanent Magnet

Reward based optimization of resonance-enhanced piezoresponse spectroscopy

X-band rapid-scan EPR of samples with long electron spin relaxation times: a comparison of continuous wave, pulse and rapid-scan EPR

A first demonstration of active feedback control and multi-frequency imaging techniques for kinetic inductance detectors

Adaptive control for downhole nuclear magnetic resonance excitation