Abstract:The functionalization of an Atomic Force Microscope (AFM) cantilever with a colloidal bead is a widely used technique when the geometry between the probe and the sample must be controlled, particularly in force spectroscopy. But some questions remain: how does a bead glued at the end of a cantilever influence its mechanical response ? And more important for quantitative measurements, can we still determine the stiffness of the AFM probe with traditional techniques? In this article, the influence of a colloidal mass loading on the eigenmodes shape and resonant frequency is investigated by measuring the thermal noise on rectangular AFM microcantilevers with and without a bead attached at their extremities. The experiments are performed with a home-made ultra-sensitive AFM, based on differential interferometry. The focused beam from the interferometer probes the cantilever at different positions and the spatial shapes of the modes are determined up to the fifth resonance, without external excitation. The results clearly demonstrate that the first eigenmode almost doesn't change by mass loading. However the oscillation behavior of higher resonances present a marked difference: with a particle glued at its extremity, the nodes of the mode are displaced towards the free end of the cantilever. These results are compared to an analytical model taking into account the mass and the inertial moment of the load in an Euler-Bernoulli framework, where the normalization of the eigenmodes is explicitly worked out in order to allow a quantitative prediction of the thermal noise amplitude of each mode. A good agreement between the experimental results and the analytical model is demonstrated, allowing a clean calibration of the probe stiffness.

Calibration of atomic force microscope probes using a pneumatic micromanipulation system

Calibration of the Effective Spring Constant of Ultra-Short Cantilevers for A High-Speed Atomic Force Microscope

Towards High Accuracy Surface Profile Characterization in Atomic Force Microscopy

Large colloidal probes for atomic force microscopy: Fabrication and calibration issues

Calibrate the Non-Orthogonal Error of AFM with Two-Dimensional Self-Traceable Grating.

Fractionized Calibration of the Sample Stage Used in an AFM-probe Mechanical Testing System

Kinematic Calibration for Articulated Arm Coordinate Measuring Machines Base on Particle Swarm Optimization

Antigen spreading-induced CD8+T cells confer protection against the lethal challenge of wild-type malignant mesothelioma by eliminating myeloid-derived suppressor cells

Atomic Force Microscope in Liquid with A Specially Designed Probe for Practical Application

Calibration of the spring constant of AFM micro-cantilever based on bending method

Lateral force calibration for atomic force microscope cantilevers using a suspended nanowire

Comparison and Analysis of Different Methods in Calibration of the Spring Constant of AFM Cantilever Probes

Application of calibrated and reusable probes on a home-made scanning probe microscope platform

Automated Nanomanipulation with Afm by Using L-1 Adaptive Controller

A Contactless Methodology of Picking Up Micro-Particles from Rigid Surfaces by Acoustic Radiation Force

Improved Calibration System of Micro-Cantilever Spring Constant

Research of the Atomic Force Microscopy Profilometer System

Functionalized AFM probes for force spectroscopy: eigenmodes shape and stiffness calibration through thermal noise measurements

Atomic Force Microscope-Based Nanomanipulation with Drift Compensation

A virtual instrument to standardise the calibration of atomic force microscope cantilevers

A novel technique of microforce sensing and loading