Abstract:A discrete element method (DEM) model is developed to simulate the dynamics of wet, flexible fibers. The angles of repose of dry and wet fibers are simulated, and the simulation results are in good agreement with experimental results, validating the wet, flexible fiber model. To study wet fiber flow behavior, the model is used to simulate shear flows of wet fibers in a periodic domain under Lees-Edwards boundary conditions. Significant agglomeration is observed in dilute shear flows of wet fibers. The size of the largest agglomerate in the flow is found to depend on a Bond number, which is proportional to liquid surface tension and inversely proportional to the square of the shear strain rate. This Bond number reflects the relative importance of the liquid-bridge force to the particle's inertial force, with a larger Bond number leading to a larger agglomerate. As the fiber aspect ratio (AR) increases, the size of the largest agglomerate increases, while the coordination number in the largest agglomerate initially decreases and then increases when the AR is greater than four. A larger agglomerate with a larger coordination number is more likely to form for more flexible fibers with a smaller bond elastic modulus due to better connectivity between the more flexible fibers. Liquid viscous force resists pulling of liquid bridges and separation of contacting fibers, and therefore it facilitates larger agglomerate formation. The effect of liquid viscous force is more significant at larger shear strain rates. The solid-phase shear stress is increased due to the presence of liquid bridges in moderately dense flows. As the solid volume fraction increases, the effect of fiber-fiber friction coefficient increases sharply. When the solid volume fraction approaches the maximum packing density, the fiber-fiber friction coefficient can be a more dominant factor than the liquid bridge force in determining the solid-phase shear stress.

Fiber Scale Numerical Investigations on Water Droplet Dynamics on Gas Diffusion Layers

On the Dynamics of Head-on Collision of Sessile Droplets on the Traveling Substrate

Molecular dynamics simulation of single droplet behavior on the windward side of a fiber filter during coalescence

Capillary-driven migration of droplets on conical fibers

Numerical simulation on velocities of two interacting fibers in fiber suspension

Discrete element simulation studies of angles of repose and shear flow of wet, flexible fibers.

A many-body dissipative particle dynamics study of eccentric droplets impacting inclined fiber

Experimental analysis of water-droplet–fiber interaction on a mechanically excited hydrophobic fiber

Dispersion phenomena of liquid droplet impacting on the single fiber with different wettabilities

A Numerical Study on Gas-Fluidized Beds of Wet Flexible Fibers

Characteristics of Fiber Suspension Flow in a Turbulent Boundary Layer

Investigation of the interactions between two contact fibers in the fiber suspensions

Numerical simulation of two-dimensional squeeze-expansion flow of fiber suspensions

Research on the Interaction of Three Contact Fibers in the Fiber Suspensions

Pressure Gradient Force, Saffman Lift, and Magnus Lift on the Fiber-like Particle in Fluid

Static wetting of a barrel-shaped droplet on a soft-layer-coated fiber

NUMERICAL RESEARCH ON THE EFFECT OF FIBERS ON THE PROPERTY OF TURBULENT FIBER SUSPENSION IN A CHANNEL

Dynamics of Droplet Coalescence on Hydrophobic Fibers in Oil: Morphology and Liquid Bridge Evolution

Liquid films falling down a vertical fiber: modeling, simulations and experiments

Multiple droplets on a conical fiber: formation, motion, and droplet mergers

Evaporation of liquid coating a fiber