Abstract:A large campaign of characterization of the ductile to brittle transition temperature (DBTT) and microstructure has been performed on several commercial and lab-scale pure tungsten grades, potassium doped tungsten alloys, and particle reinforced tungsten grades (with particles of TiC, Y2O3, or ZrC), all integrated in a large-scale neutron irradiation campaign. The DBTT is deduced based on miniaturized three-point bending tests to provide reference data for the assessment of the irradiation effects on the tungsten alloys. This miniaturized geometry is designed to minimize the operational cost of neutron irradiation, to speed up post-irradiation examination, and to reduce the amount of nuclear waste. The resulting DBTT ranges from around −15 up to 450 °C, depending on the material. The potassium doped tungsten alloys have the lowest DBTT, followed by rolled ZrC reinforced tungsten grade, commercial pure tungsten grades, lab-scale pure tungsten grades, and other particle reinforced tungsten grades. The crack plane orientation and microstructure with respect to grain shape and grain boundaries significantly affect the DBTT for forged/rolled tungsten products with elongated grains. The L-T orientation has a lower DBTT compared to the T-L orientation. Moreover, the DBTT difference in the L-T and T-L orientation raises with increasing the grain aspect ratio. An attempt is made to establish a relationship between the density of low and high angle grain boundaries and DBTT value. The obtained relationship is discussed in the frame of mechanical processing (i.e., rolling or forging) to optimize the DBTT by optimized manufacturing. The results are compared to recent computational predictions of the DBTT in tungsten.

Measurement of Ductile-Brittle Transition Temperature of Tungsten Materials by Four-Point Bending Method and Its Comparison with Other Methods

Ductile to brittle transition temperature of advanced tungsten alloys for nuclear fusion applications deduced by miniaturized three-point bending tests

Anisotropic factors affecting the ductile-brittle transition of rolled‐tungsten after different recrystallization treatments

High-pressure Preparation of Bulk Tungsten Material with Near-Full Densification and High Fracture Toughness

Mechanism of Brittle-to-ductile Transition in Tungsten under Small-Punch Testing

The Ductile-Brittle Transition Behaviors of W/Ta Multilayer Composites

High-temperature tensile and thermal shock characterization of low-temperature rolled tungsten

Effect of Anisotropic Mechanism of W-2%wt Y2O3 Alloy on DBTT and Fracture Analysis under Small Punch Testing

Study of estimation of ductile-brittle transition temperature using U-notched small punch test specimens

Experimental Study on Fracture Toughness of Butt Weld of Q460C High-Strength Structural Steel

Temperature-Dependent Deformation and Fracture Properties of Low-Carbon Martensitic Steel in Different Stress States

Investigation on Detection Method for Ductile-brittle Transition Temperature of 400-18LT Ductile Iron

Study of Fatigue Properties of Graphite Materials under Four-Point Bending

Temperature Dependence of the Friction and Wear Behavior of Pure Tungsten

A Novel Small Specimen Testing Method Based on a Pneumatic Bulging Test: Measurement of Tensile Properties at High Temperatures

Timely and atomic-resolved high-temperature mechanical investigation of ductile fracture and atomistic mechanisms of tungsten

Evaluation of Ductile-Brittle Transition Temperature in Electron-Beam Welded Steel by Small Punch Test(Student Poster Session)

Tensile impact behavior of duplex Ti-46.5Al-2Nb-2Cr at elevated temperatures

The Fracture Toughness of Butt Weld at Low Temperature of 960 MPa High-strength Steel

Damage Behaviors in Microstructures and Mechanical Properties of Pure Tungsten Induced by Repetitive Thermal Loads

Four Point Bending Experimental Investigation on Reinforced Ultra High Toughness Cementitious Composite Beams