Abstract:In this article, an enhanced class-F voltage-controlled oscillator (VCO) with common-mode-noise self-cancellation (CM-NC) and common-mode-noise isolation (CM-NI) technique is proposed. With the proposed CM-NC technique, the common-mode-noise current of the drain coil and that of the nearby source coil are in the opposite direction. Therefore, the magnetic fields generated by the two coils cancel each other, which reduces the noise injected into the VCO from power supply and the ground node. Moreover, the principle of decoupling between the two inductors is also employed to eliminate the influence of the common-mode tail inductor on the differential mode. By winding the gate coil into a double-turn structure, the coupling noise from the drain inductor to the gate is opposite to the induced current of the gate coil, thereby cutting off the noise coupling path from the drain to the gate. Thanks to the dual-core 8-shaped inductor structure, the phase noise (PN) is improved without increasing the area, compared with existing methods using separated and dedicated tail filtering inductors. The VCO is fabricated in a 65-nm complementary metal–oxide–semiconductor (CMOS) technology. The measured tuning range is 21.7% from 11.5 to 14.3 GHz. The PN and figure of merit (FoM) at 1-MHz offset are $-$ 119.2 and 192.8 dBc/Hz, respectively. The power consumption across the frequency tuning range is 5.6–10 mW. The core area is 0.065 mm $^{2}$ and the total area is 0.26 mm $^{2}$ .

A Current-Reused VCO with Inductive-Transformer Feedback Technique

An Inverted Complementary Cross-Coupled VCO to Reduce Phase Noise Sensitivity to KVCO

A Low Phase Noise VCO with Placement Reordered Cores and High-Q Bond Wire Array Inductors

A 3.7-Mw $K$ -Band Dual-Feedbacks VCO Employing a Self-Inversed Transformer with 190-Dbc/hz FOM

A Ku-Band 20.4% Tuning Range VCO with a Tunable Harmonic-Resonant Transformer in 55 Nm CMOS

A 4.4-Ghz 193.2-Db FoM 8-Shaped-inductor Based LC-VCO Using Orthogonal-Coupled Triple-Coil Transformer

A 3 GHz Low Power LC VCO with Voltage Boosted Circuit from 0.5 V Supply

An Ultra-Low-Voltage High-Performance VCO in 0.13 μm CMOS

A 2.15–6.18 GHz transformer-based dual-mode LC-VCO with current-reuse technology

An Enhanced Class-F Dual-Core VCO With Common-Mode-Noise Self-Cancellation and Isolation Technique

A Low Phase Noise 8.8 GHz VCO Based on ISF Manipulation and Dual-Tank Technique

A 1mW 5GHz current reuse CMOS VCO with low phase noise and balanced differential outputs

A Low-Phase-Noise Quad-Core Millimeter-Wave Fundamental VCO Using Circular Triple-Coupled Transformer in 65-Nm CMOS

A 24ghz Low Phase Noise Feedback Cmos Lc-Vco

A 4.9–6.9 GHz LC VCO with low-phase-noise

A 6-GHz low-phase-noise voltage-controlled oscillator

A 12.9-to-24 GHz Dual-Mode Multi-Coil VCO Achieving 199.2 Dbc/hz Peak FoMT in 65-Nm CMOS

A Low-Phase-Noise VCO with Common-Mode Resonance Expansion and Intrinsic Differential 2Nd-Harmonic Output Based on a Single Three-Coil Transformer

A Uniform Phase Noise QVCO with a Feedback Current Source

A 80.4-to-86.5 GHz E-band QVCO with Inductor Tuning Method and Amplifier Feedback in 65-Nm CMOS Technology

A 0.73 Mw Low Power 9.6 GHz LC Voltage-Controlled Oscillator Achieves Constant KVCO and −189.2 FOM