Abstract:Ultrashort pulse laser heating is not only capable of resolving and observing the ultrafast interaction of energy carriers, i. e. electrons, phonons, but also widely applied to material processing, i. e., laser ablation. However, the previous theories, i. e., two-temperature model, parabolic one-step model, can be applied only to some limited segments. In this paper, according to the two-temperature model and Fourier's law, a general theoretical model is presented for the description of the entire heat relaxation process after the thin metal film deposited on the substrate has been heated by the ultrashort pulse laser. Moreover, the heat conduction process is also experimentally studied by using the rear-pump front-probe transient thermoreflectance technique on Au/glass and Au/SiC at 300 K, and the theoretical prediction accords well with the experimental result, which illustrates the validity of the present theoretical model. Based on the good agreement between theoretical predictions and experimental data, the electron-phonon coupling factor of the thin gold film and thermal boundary conductance of the Au/glass and Au/SiC interfaces are extracted and the measured results are in good agrement with the previous reported values. The electron-phonon coupling factor is close to that of the bulk material and does not exhibit size effect. The thermal boundary conductance is greater than the prediction of diffuse mismatch model, and the reasons responsible for the discrepancies are electrons participating in the interfacial heat conduction, interfacial atom diffusion and inelastic scattering. © 2011 Chinese Physical Society.

Experimental and Numerical Studies on Micro-Bumps Without Melting of Gold Films with Different Thicknesses Induced by Ultrafast Laser

Bump Deformation of Gold Film Induced by Ultrafast Laser

Study on Deformations of Gold Film Induced by Ultrafast Laser at GHz Burst Mode

Atomic-Level Study of A Thickness-Dependent Phase Change in Gold Thin Films Heated by an Ultrafast Laser

An Atomic-Level Study of Material Ablation and Spallation in Ultrafast Laser Processing of Gold Films

Structural Transition Dynamics of the Formation of Warm Dense Gold: from an Atomic Scale View

Thermomechanical Interaction in Metal Films During Ultrashort Laser Heating

Electron Relaxation Effect on the Sub-100-fs Laser Interaction with Gold Thin Film.

Integrated Continuum-Atomistic Modeling of Nonthermal Ablation of Gold Nanofilms by Femtosecond Lasers

Nonequilibrium Phase Change in Gold Films Induced by Ultrafast Laser Heating.

The Formation of Different Structures in the Interaction Between A Single Femtosecond Laser Pulse and A Thin Au Film

Investigation of splashing phenomena during the impact of molten sub-micron gold droplets on solid surfaces

Ultrafast Laser-Induced Premelting and Structural Transformation of Gold Nanorod

Experimental Study on Laser Microstructures Using Long Pulse

Investigation of Impact and Spreading of Molten Nanosized Gold Droplets on Solid Surfaces.

Effect of Pulsed Laser Irradiation on Microstructure and Evolution of Residual Stress for Gold Film

Hydrodynamic Simulation of Ultrashort Pulse Laser Ablation of Gold Film

Ultrafast Dynamics of Laser Thermal Excitation in Gold Film Triggered by Temporally Shaped Double Pulses

Theoretical and experimental study of femtosecond pulse laser heating on thin metal film

Elongation rate measurements of nanofilms by microbump method induced by laser pulse

Research on the influence of laser molten pool flow and evaporation on the bump texture forming of aluminum plate surface