Abstract:This research is to investigate the feasibility and practicability of carrying out an experimental work to support the seismic assessment of High Temperature Reactor Pebble bed Module (HTR-PM) reactor graphite core structure, which contains thousands of graphite bricks and tens of thousands of keys/dowels. The seismic responses of HTR-PM reactor under the seismic and impact conditions are beyond the applicability of the analytical methods currently employed, and the experimental program would be required to enhance the development of alternative analytical method and extensions of the current methods. This work can provide information and judgments for potential future work that would be nuclear safety related. The seismic excitations applied on the 1:2 double-layer graphite core model without side and top metallic components support, which is part of HTR-PM side reflector structure, included: (a) the white noise excitation from 0.1g to 0.5g amplitude in two orthogonal directions; (b) sine-sweep, frequency band from 1.0 to 35.0 back to 1.0 Hz, sweep rates less than 2 oct/min while 1 oct/min around resonant frequencies, at constant 0.5g amplitude in one horizontal uniaxial excitation; (c) five OBEs (Operating Basis Earthquake) up to 7.4g and (d) one SSE (Safe Shutdown Earthquake) up to 8.0g by considering scale law; (e) Four similar models have been tested with different gaps (1.6, 3.0 and 5.0mm) between bricks and with/without holddown plates, which can indicate approximately core structure characteristic at different lifetime for graphite irradiation deformation. The response of acceleration and displacement are measured in the tests. The natural frequencies of double layers model, bricks radial and tangential relative displacement have been calculated from the test results. Damaged graphite components have been counted and analyzed. The purpose of the test is to (a) investigate model dynamic behavior and response characteristics of integrated graphite components, (b) verify model scaling laws; (b) provide specific data on bricks relative displacement, acceleration; (c) provide data for correlation with analytical models; (d) verify the seismic analysis code to be developed in INET, and (e) optimize the detail design for HTR-PM project. The preliminary simulation results achieved good agreement with the data obtained from the test.

Shaking Table Test and Numerical Analysis of a Coal-Fired Power Plant Equipped with Large Mass Ratio Multiple Tuned Mass Damper (LMTMD)

Seismic Performances of a Structure Equipped with a Large Mass Ratio Multiple Tuned Mass Damper

Shaking Table Test of the Shock Absorbing Performance of a New Cable‐damper Stopper for Coal‐fired Thermal Power Plants

Shaking Table Model Test And Fe Analysis Of A Reinforced Concrete Mega- Frame Structure With Tuned Mass Dampers

Shaking table test and numerical simulation of the vibration control performance of a tuned mass damper on a transmission tower

Shaking Table Test on Multi-Dimensional Seismic Response of Structure and Nuclear Power Equipment Coupled System

Seismic behavior of RC structures with absence of floor slab constraints and large mass turbine as a non-conventional TMD: a case study

Shaking table tests of electromagnetic mass damper system for control of structural seismic response

Experimental study of seismic response reduction effects of particle damper using substructure shake table testing method

Seismic retrofit design and risk assessment of an irregular thermal power plant building

Effects of soil–structure interaction on the design of tuned mass damper to control the seismic response of wind turbine towers with gravity base

Experimental Study of the Semi‐active Control of Building Structures Using the Shaking Table

Optimization of the Seismic Performance of a Steel-Concrete Wind Turbine Tower with the Tuned Mass Damper

Real-Time Hybrid Simulation of Multi-Story Structures Installed with Tuned Liquid Damper

Shake table test and seismic fragility analysis of transmission tower-line system considering duration effect

Seismic performance of soft soil foundation with a new type of assembled wall tuned mass damper

Dynamic response and optimal design of structures with large mass ratio TMD

Shaking table test and seismic behaviour evaluation of viscous damping wall with amplification mechanism

Seismic Test and Analyses on Double-Layer Model of Htr-Pm Graphite Structure

Semi-Active Control for Benchmark Building Using Innovative TMD with MRE Isolators

Seismic structural responses reduction of double-layered containment nuclear power plant via BIS-TMD