Abstract:Surface texturing is an effective technology for enhancing lubrication and anti-wear properties through hydrodynamic effects and secondary lubrication. In this study, two types of variable-depth groove textures were designed to enhance the lubrication performance of friction pairs. Based on theoretical analysis, the coefficient of friction (COF), wear characteristics, and triboelectric open-circuit voltages produced by different textures were evaluated in a series of experiments. Using a friction testing setup, scanning electron microscopy, energy dispersive spectrometry, an electrometer (Keithley 6514), Raman spectroscopy, surface microtopography, and lubrication mechanisms were revealed. First, two types of variable-depth groove textures were designed based on computational fluid dynamics. Second, SiC samples with these textures were fabricated using laser surface texturing technology, and ball–disk rotary friction experiments were performed. During the friction tests, the shallow inner and deep outer (SDT) groove textures exhibited a lower COF at medium and low speeds under varying loads. Finally, the lubrication mechanism was attributed to the synergistic effect of four factors: the hydrodynamic effect of the lubricant, enhanced ability of debris expulsion, oxide tribofilms at the interface, and polarization electric field generated at the solid–liquid interfaces between the lubricant and friction pair. The results indicate that the minimum COF of the SDT texture can be reduced to 0.025. These insights offer valuable guidance for design methods and new lubrication mechanisms for enhancing the lubrication and anti-wear properties of friction pairs in mechanical systems.

Enhanced Tribological Property of Mechanical Seal in Water Environment by Nanosecond Laser Surface Texturing

Effects of Laser Surface Texturing and Lubrication on the Vibrational and Tribological Performance of Sliding Contact

Mechanical Seal Face Texturing by the Acousto-Optic Q-Switched Pulsed Nd:Yag Laser

Experimental investigation of the effect of typical surface texture patterns on mechanical seal performance

Improving Tribological Performance of Mechanical Components by Laser Surface Texturing

Tribological behaviors of laser textured surface under different lubrication conditions for rotary compressor

Evaluation of tribological performance for laser textured surfaces with diverse wettabilities under water/oil lubrication environments

Experimental Study on Texture Coupling Mechanism and Antifriction Performance of Piston Rod Seal Pair

Influence of diamond-like carbon coatings and micro-texturing on friction and wear of seal interfaces: Experiment and simulation study

An Experimental Investigation of Tribological Performance of Triangular Textures in Water Lubrication Regime

Additional Tribological Effect of Laser Surface Texturing and Diamond-Like Carbon Coating for Medium Carbon Steel at Near Room Temperature

Fabrication and tribological characterization of laser textured engineering ceramics: Si3N4, SiC and ZrO2

Sealing performance and optimization design of squamous textured mechanical seal

Synergistic Effect of Elliptic Textures and H-DLC Coatings for Enhancing the Tribological Performance of CuAl10Fe5Ni5 Valve Plate Surfaces

Experimental study of two-phase mechanical face Seals with laser surface texturing

Improvement of current-carrying tribological behaviour via laser surface texture

Optimization of Tribological Characteristics of a Combined Pattern Textured Surface Using Taguchi Design

Study on the Tribological Properties of Multilayer Concentric Hexagonal Laser Texturing on Rubber Surfaces of Screw Pumps

Anti-Wear Property of Laser Textured 42CrMo Steel Surface

Effect of Compound Texture on Lubrication and Sealing Performance of Plunger Pump

Influence of Variable-Depth Groove Texture on the Friction and Wear Performance of GCr15–SiC Friction Pairs Under Water Lubrication