Abstract:In this research, the mechanical behaviors of extruded AZ31B Mg plate along normal direction (ND) were investigated over a wide range of strain rates. High strain rate tests were carried out using a split Hopkinson pressure bar at room temperature. The corresponding deformation mechanisms, texture evolution and microstructure changes were analyzed by utilizing optical microscope (OM), X-ray diffraction (XRD), electron backscatter diffraction (EBSD) and transmission electron microscopy (TEM). It is found that the mechanical responses exhibit both sigmoidal hardening and power-law hardening behaviors under compression at high strain rate ranges of 1068-5647 s(-1). The prismatic type textures of the skin layer and center layer of the AZ31B plate determine its mechanical behaviors. The sigmoidal hardening behaviors are resulted from the formation and development of {10-12} extension twinning at the initial stage of deformation. Whereas the power-law hardening behaviors are resulted from non-basal < c+a > dislocation slip dominated the deformation at the initial deformation stage. Experimental results indicate the critical resolved shear stress (CRSS) for extension twinning and non-basal < c+a > dislocation slip are insensitive to strain rate, but the latter CRSS is significantly higher than the former CRSS. The flow stress is insensitive to strain rate if plastic deformation is dominated by extension twinning, while it increases with the increase of strain rate if plastic deformation is dominated by nonbasal < c+a > dislocation slip. Dynamic recrystallization (DRX) took place if the AZ31B plate was compressed at strain ranges of 4737-5647 s(-1), resulting in a decrease in flow stress and a significant increase in ductility. (C) 2016 Elsevier B.V. All rights reserved.

Dynamic Compression Behavior and Microstructure of Extruded ZM61 Magnesium Alloy under High Strain Rates

Tensile Mechanical Properties and Deformation Mechanism of the Extruded ZM61 Magnesium Alloy at High Strain Rates

Microstructure and mechanical properties of extrusion ZC61 alloys under different dynamic compression loading directions

Investigation of the microstructure and properties of extrusion-shear deformed ZC61 magnesium alloy under high strain rate deformation

Dynamic Compressive Behaviour and Microstructural Evolution of Extrusion-Shear Mg–6Zn–1Cu–1Y–0.6Zr Alloy

Fracture Behavior of Twin Induced Ultra-Fine Grained ZK61 Magnesium Alloy under High Strain Rate Compression

Microstructural Evolution of Mg–6Zn–0.6Zr Alloy During High Strain Rate Compression Deformation

Effects of High Strain Rate on Mechanical Properties of As-extruded AZ61 Magnesium Alloy

Dynamic compression behaviour and microstructural evolution of the Mg–6Zn–2Ce–0.6Zr alloy

Dynamic plasticity of AZ31 magnesium alloy: Experimental investigation and constitutive modeling

Effect of Grain Size on Dynamic Compression Behavior and Deformation Mechanism of ZK60 Magnesium Alloy

Dynamic compression properties and microstructural evolution of ZCW612 alloy under different strain levels

Microstructural Study of a Mg-Zn-Zr Alloy Hot Compressed at a High Strain Rate

Microstructural characterization and mechanical response of the extruded ZK61 magnesium alloy under dynamic and quasi-static loading

Dynamic Compression Behaviour and Microstructure of ZK60 Alloy under Different Strain Rates

Hot compression deformation behavior of extruded ZK60 magnesium alloy

Hot Deformation Behavior and Workability of Pre-Extruded ZK60A Magnesium Alloy

Research on the Properties of Mg-3Al-6Zn-2Y Alloy under Dynamic Compression

Anisotropy and Deformation Mechanisms ofAs-Extruded Mg-3Zn-1Y Magnesium AlloyUnder High Strain Rates

Dynamic mechanical response and microstructural evolution of extruded Mg AZ31B plate over a wide range of strain rates

Flow Curve and Microstructure Analysis of a ZK60 Magnesium Alloy during Hot Compression Tests