Abstract:In this paper, an optimized process for preparation of photosensitive nanosilica from rice husk (RH) is described. The rice husk sample was pretreated by soaking in deionized water to remove most of the alkali metals and partial fixed carbon. Most metal oxides, especially alkaline metal oxides and alkaline-earth metal oxides, were removed to a certain extent after the soaking pre-treatment. Soaking pretreatment may remove the hydrogen bonds or extractives between hemi-cellulose and cellulose, which affects the thermal stability of both molecules. To thoroughly analyze the soaking process, thermogravimetric analysis (TGA) was performed to obtain the mass loss behavior of soaked rice husk. The characteristics of the nanosilica prepared from the method described in this paper are superior to those of fumed silica. The silica content of the nanosilica reached a record of 99.92% in pyrolysis method. The optimum preparation conditions were as follows: a rice husk feedstock particle size of between 250 and 420 mu m, a pyrolysis temperature of approximately 610 degrees C, a hydrolysis temperature of 120 degrees C, a 1:10 (g/ml) ratio of rice husk to acid, a hydrolysis time of 4 h, and a hydrochloric acid (HCI) concentration of 8% (wt.%). A detailed study of the effects of the pyrolysis temperature and feedstock particle size was conducted, filling the gap in systematic research on the nanosilica preparation process using the pyrolysis method. The complete process of pyrolysis for pretreated rice husk is described, including the decomposition of the major constituents, volatilization of gases and the formation of silica. The results of this study provide a deep understanding of nanosilica production by pyrolyzation. The prepared nanosilica is photosensitive and approximately spheroidal with an average particle size of approximately 8-10 nm. (C) 2013 Elsevier B.V. All rights reserved.

Experimental Study on Preparation of Amorphous SiO2 by Fluidized Bed Combstion of Rice Husk

Production of Amorphous Rice Husk Ash in a 500 Kw Fluidized Bed Combustor

Production and characterization of silica materials from rice husk ash by different combustion processes

Catalytic Fast Pyrolysis of Rice Straw to Aromatics over Hierarchical HZSM-5 Treated with Different Organosilanes

A New Process to Resource Rice Hull

Experimental Study on Rice Husk Combustion in a Circulating Fluidized Bed

Kinetic study on the preparation of silica from rice husk under various pretreatments

Study on combustion characteristics of rice husk-fired fluidized bed boiler

Experimental Investigation of Ash Deposits Characteristics of Co-Combustion of Coal and Rice Hull Using a Digital Image Technique

Bed Agglomeration and Straw Ash Behavior During Fluidized Bed Combustion of Rice Straw

Mechano-chemical conversion of rice husk ash and gasifier-derived rice husk ash into porous silicon

Silica White Obtained from Rice Husk in a Fluidized Bed

Upgrading the rice husk char obtained by flash pyrolysis for the production of amorphous silica and high quality activated carbon

Experimental Investigation on the Flow Characteristics of Rice Husk in a Fuel-Rich/lean Burner

99/00594 Experimental research on rice husk combustion in CFB boiler and the design of a 35T/H rice husk-fired CFB boiler

Preparation of highly dispersed nanosilica from rice husk by aprecipitation method combined with high pressure homogenization

Co‐combustion and ash characteristics of Zhundong coal with rice husk hydrochar prepared by the hydrothermal carbonization technology for co‐combustion

A Detailed Study of the Effects of Pyrolysis Temperature and Feedstock Particle Size on the Preparation of Nanosilica from Rice Husk

A Comparative Study on Rice Husk, as Agricultural Waste, in the Production of Silica Nanoparticles via Different Methods

Synthesis of silica and carbon-based nanomaterials from rice husk ash by ambient fiery and furnace sweltering using a chemical method

Co-firing raw and torrefied rice husk with a high-Na/Ca/Cl coal: Impacts on fine particulates emission and elemental partitioning