Failure Pattern and Load Distribution Mechanism of Stiffeners in the Tube–gusset Plate Connection: Testing, Numerical Modelling and Theoretical Analysis

Songzhao Qu,Quangeng Li,Yi Wang,Jun Yuan,Qing Sun

DOI: https://doi.org/10.1016/j.istruc.2021.12.049

IF: 4.1

2022-01-01

Structures

Abstract:In tube–gusset plate connection (TGPC), the deformation stiffness of the stiffener plate is much greater than that of chord wall. The local instability and material failure in the stiffener plate are the primary failure modes of TGPC. In this article, an experimental, numerical and theoretical study on both the failure pattern and internal force distribution mechanism of the stiffener ring plates in the TGPC was carried out. An experimental study including the material tensile coupon tests and twelve TGPC tests was initially conducted, which detailedly presented the failure modes of the stiffener plates under either compression or tension. The failure of the stiffener plates was dominated by local instability when compression and was controlled by material failure when tension. Subsequently, a numerical investigation using finite element models (FEMs) of KT– and X–type joints was performed. The FEMs were validated against the present test results and those available in literature. Thereafter, in order to obtain the additional data of TGPC with multi–stiffener ring plates and verify the accuracy of the calculation model proposed below, the FEMs were then extended for a further investigation of the TGPCs containing three, four, and five ring stiffener plates with different gusset plate lengths. With considering the influence of the bending deformation in the plane of gusset plates on the distributed loads in stiffener ring plates, an elastic beam–spring bearing (EBSB) model was developed based on the conjugate beam theory. Finally, the numerical results were compared with those obtained using the Japanese code and EBSB model. It was seen that the influence of the bending deformation of the gusset plate on distributed loads in the stiffener ring plates became significant, and the proportion of the shear deformation of the gusset plate between the stiffeners to the total deformation was decreased, when the length of the gusset plate was increased. The distributed load in each stiffener ring plate predicted by the EBSB model was found to be more accurate than that obtained using the Japanese code. The proposed EBSB model can be used as the guidelines for the design of joints in actual transmission line engineering projects.