Abstract:Automated fiber placement (AFP) in situ consolidation of continuous CF/high-performance thermoplastic composite is the key technology for efficient and low-cost manufacturing of large thermoplastic composites. However, the void in the in situ composite is difficult to eliminate because of the high pressure and the short consolidation time; the void content percentage consequently is the important defect that determines the performance of the thermoplastic composite parts. In this paper, based on the two-dimensional Newtonian fluid extrusion flow model, the void dynamics model and boundary conditions were established. The changes of the void content percentage were predicted by the cyclic iteration method. It was found that the void content percentage increased gradually along the direction of the layers’ thickness. With the increasing of the laying speed, the void content percentage increased gradually. With the increasing of the pressure of the roller, the void content percentage gradually decreased. When the AFP speed was 11 m/min and the pressure of the compaction roller reached 2000 N, the void content percentage of the layers fell below 2%. It was verified by the AFP test that the measured results of the layers’ thickness were in good agreement with the predicted results of the model, and the test results of the void content percentage were basically equivalent to the predicted results at different AFP speeds, which indicates that the kinetic model established in this paper is representative to predict the void content percentage. According to the metallographic observation, it was also found that the repeated pressure of the roller was helpful to reduce the void content percentage.

Modeling and Multiparametric Effect on Void Content in Composite Tape Winding

Modeling and Simulation of Voids in Composite Tape Winding Process Based on Domain Superposition Technique

Study on Void Formation in Multi-Layer Woven Fabrics

MECHANISM OF VOID FORMATION IN TEXTILE PREFORM-MULTI-LAYER WOVEN FABRICS

Research on Void Dynamics during In Situ Consolidation of CF/High-Performance Thermoplastic Composite

Modeling of Void Formation Based on Non-isothermal Conditions in Liquid Composite Molding for Plain-weave Fabric

Influence of Processing Parameters on Void Content in VARI Manufacturing Techniques

Influence of fabric shear and flow direction on void formation during resin transfer molding

Out-of-plane Tensile Failure Behavior of Fiber Reinforced Composites Due to Lay-Up Temperature Induced Intra-Ply and Inter-Ply Voids

Influence of process parameters on resin content of filament-wound composite based on simulation of dual-phase resin flow

MODULATING VOID ACTION AND RESIDUAL STRESS VARIATION OF COMPOSITE MATERIALS DURING CURING PROCESS

Transverse squeeze flow of thermoplastic composite tape during in-situ consolidation via automated fiber placement

Micro-mesoscopic Prediction of Void Defect in 3D Braided Composites

Critical Void Content for Thermoset Composite Laminates

An Enhanced Vacuum-Assisted Resin Transfer Molding Process and Its Pressure Effect on Resin Infusion Behavior and Composite Material Performance

Theoretical and experimental analysis on void formation in epoxy composite laminates

Effect of Manufacturing Defect on Mechanical Performance of Plain Weave Carbon/epoxy Composite Based on 3D Geometrical Reconstruction

Effect of Manufacturing Defects on Mechanical Properties and Failure Features of 3D Orthogonal Woven C/C Composites

Effect Mechanism and Simulation of Voids on Hygrothermal Performances of Composites

Tension relaxation during the NOL ring winding process based on a novel tracking element method

On the temperature evolution during continuous laser-assisted tape winding of multiple C/PEEK layers: The effect of roller deformation