Abstract:A comprehensive modeling framework for the thermoforming of polymer matrix woven laminate composite was developed. Two numerical indicators, the slip path length and traction magnitude, have been identified to be positively correlated to matrix smearing and wrinkling defects. The material model has been calibrated with picture-frame experimental results, and the prediction accuracy for intra-ply shear and thickness distribution was examined with measurements of the physically formed parts. Specifically, thickness prediction for most locations on the formed parts was accurate within an 11.6% error margin. However, at two points with significant intra-ply shear, the prediction errors increased to around 20%. Finally, a parametric study was conducted to determine the relationship between various process parameters and the quality of the formed part. For the trapezoidal part, orienting the laminate at 45 degrees to the mold axis reduces the likelihood of matrix smear and wrinkling defects. Although this laminate orientation yielded a greater spatial variation in part thickness, the thickness deviation is lower than that for the 0-degree orientation case. Two forming analyses were conducted with ramp rates of 25 mm/s and 80 mm/s to match the equipment's operational limits. It was observed that higher forming rates led to a greater likelihood of defects, as evidenced by a 15% and 10% increase in the formed part areas with longer slip paths and higher traction magnitudes, respectively. It was discovered that shallower molds benefit from faster ramp rates, while deeper molds require slower rates to manage extensive shearing, stretching and bending. Faster forming rates lead to smaller thickness increases at high intra-ply shear regions, indicating a shift from intra-ply shear to out-of-plane bending due to the visco-plastic effect of the molten laminate and can negatively impact part quality. Lastly, it was shown that a well-conceived strategy using darts could improve the part quality by reducing the magnitude of the defect indicators.

Transverse squeeze flow of thermoplastic composite tape during in-situ consolidation via automated fiber placement

Modeling and experimental validation of compaction pressure distribution for automated fiber placement

An experimental validation study of a numerical modeling approach to predicting post-consolidation dimensions of thermoplastic composites

Process-dependent Wrinkle Formation for Steered Tow During Automated Fiber Placement: Modeling and Experimental Verification

Compaction Pressure Distribution and Pressure Uniformity of Segmented Rollers for Automated Fiber Placement

Modeling on the Effect of Automated Fiber Placement Induced Gaps in Curved Composite Laminates

A viscoelastic-plastic model for the temperature-dependent creep and recovery behavior during dry fiber fabric compaction

Deformation and Fracture Mechanisms of Automated Fiber Placement Pre-Preg Laminates under Out-of-plane Tensile Loading

An experimental study on filling of gaps and void pockets during vacuum-bag-only consolidation of fiber placed preforms

In-situ consolidation deformation of composite laminate with gaps of various widths

Non-isothermal direct bundle simulation of SMC compression molding with a non-Newtonian compressible matrix

Thermochemical and Mechanical Aspects of Composite Tape Laying

A state-rate model for the transient wall slip effects in ply-ply friction of UD C/PAEK tapes in melt

Research on Void Dynamics during In Situ Consolidation of CF/High-Performance Thermoplastic Composite

A multiscale consolidation model for press molding of hybrid textiles into complex geometries

Analysis and modeling of the mechanical behavior of the compaction process of flexible guided 3D weaving

A Modeling Framework for the Thermoforming of Carbon Fiber Reinforced Thermoplastic Composites

Modelling approach for anisotropic inter-ply slippage in finite element forming simulation of thermoplastic UD-tapes

An Analytical Friction Model for Handling and Spreading of Carbon Fiber Tows for Composite Prepregging Applications

A General and Efficient Approach for the Dual-Scale Infiltration Flow Balancing in In Situ Injection Molding of Continuous Fiber Reinforced Thermoplastic Composites

A Squeeze Flow Problem with A Navier Slip Condition