Abstract:The purpose of the current study was to implement unequal microstrip power splitters for parallel transmission at 7 T that are optimized for size and loss and that can be configured for a wide range of power ratios. The splitters will enable the use of more transmit coils without a corresponding increase in the number of transmit channels or amplifiers to control specific absorption rate, shorten RF pulses, and shim inhomogeneous RF fields. Wilkinson unequal power splitters based on a novel microstrip network design were optimized to minimize their size under 8 cm in length and 9 cm in width, enabling them to be included in coil housing or cascaded in multiple stages. Splitters were designed and constructed for a wide range of output power ratios at 298 MHz. Simulations and bench tests were performed for each ratio, and a methodology was established to adapt the designs to other ratios and frequencies. The designs and code are open source and can be reproduced as is or reconfigured. The single-stage designs achieved good matches and isolations between output ports (worst isolation -15.9 dB, worst match -15.1 dB). A two-stage cascaded (one input to four outputs) power splitter with 1:2.5, 1:10, 1:3, and 1:6 ratio outputs was constructed. The worst isolation between output ports was -19.7 dB in simulation and the worst match of the three ports was -17.8 dB. The measured ratios for one- and two-stage boards were within 10% of the theoretical ratios. The power-handling capability of the smallest trace was approximately 70 W. Power loss for the one- and two-stage boards ranged from 1% to 3% in simulation compared with 5.1% to 7.2% on the bench. It was concluded that Wilkinson unequal microstrip power splitters can be implemented with a small board size (low height) and low loss, and across a wide range of output power ratios. The splitters can be cascaded in multiple stages while maintaining the expected ratios and low loss. This will enable the construction of large fixed transmit array-compression matrices with low loss.

Resistor-free and One-Board-fits-all Ratio Adjustable Power Splitter for Add-on RF Shimming in High Field MRI.

Hybrid‐pair Ratio Adjustable Power Splitters for Add‐on RF Shimming and Array‐compressed Parallel Transmission

A Compact Gysel Power Divider with Unequal Power-Dividing Ratio Using One Resistor

Miniaturization of Rat-Race Coupler With Dual-Band Arbitrary Power Divisions Based on Stepped-Impedance Double-Sided Parallel-Strip Line

Compact Rat-Race Coupler with Double-Sided Parallel-Strip Line (DSPSL) for Dual-Band Arbitrary Power Divisions

On the design and manufacturing of miniaturized microstripline power splitters for driving multicoil transmit arrays with arbitrary ratios at 7 T

Development of a Compact X-band Variable-Ratio RF Power Splitter

Design of a Variable X-band RF Power Splitter

Arbitrary-Ratio Power Splitters Using Area Modulation Multimode Interference Couplers

Mid-Infrared, Ultra-Broadband, Low-Loss, Compact Arbitrary Power Splitter Based on Adiabatic Mode Evolution

Compact metamaterial-inspired RF coil based on split-ring resonators to enhance the magnetic field for 1.5T magnetic resonance imaging

DESIGN OF A COMPACT VARIABLE X-BAND RF POWER SPLITTER

Design of a Compact Variable Waveguide RF Power Splitter for High-Power Applications

A high-Q metasurface signal isolator for 1.5T surface coil magnetic resonance imaging on the go

A Single-Transmitter Multi-Receiver Wireless Power Transfer System with High Coil Misalignment Tolerance and Variable Power Allocation Ratios

RF shimming strategy for an open 60-channel RF transmit 7T head coil for routine use on the single transmit mode

A Novel Design of Compact Out-of-Phase Power Divider with Arbitrary Ratio

Adaptive Radiofrequency Shimming in MRI using Reconfigurable Dielectric Materials

A Method of Using Nonidentical Resonant Coils for Frequency Splitting Elimination in Wireless Power Transfer

Compact, Broadband, and Low-Loss Silicon Photonic Arbitrary Ratio Power Splitter Using Adiabatic Taper.

Miniaturized 7–12 GHz 1-to-4 Differential Power Splitter with Low Amplitude/Phase Imbalances Using Broadside-Coupled CPW/SIDGS Scheme and Embedded CPW Spur-Line