Abstract:Laser ultrasound is a widely used tool for industrial quality assurance when a contactless and fast method is required. In this work, we used a laboratory setup based on a confocal Fabry–Perot interferometer to examine weld seam models. The focus was placed on small samples with curved surfaces (small in the sense that the radius of curvature is comparable to the largest ultrasonic wavelength) and on efficient ways to detect the presence and volume of process pores, with the goal to transfer this method to industrial applications. In addition to this experimental method for investigating welds, a numerical method that models the experimental setup was implemented in MATLAB. For this purpose, first the thermal effects of the excitation process were taken into account by solving the thermal diffusion equation with an explicit scheme. Then, the elastodynamic equations were solved using the Elastodynamic Finite Integration Technique, taking into account the stresses induced by the excitation process. The B-Scans generated with this numerical model were compared with experimental B-Scans for simple test cases and good agreement was found. In a next step, the additional structures in the B-Scans resulting from air inclusions were identified and investigated with both methods using flat test specimens at first. Besides the direct echoes, structures from skimming surface waves and multiple reflections were visible. These additional structures are unwanted in defect reconstruction methods like the Synthetic Aperture Focusing Technique (SAFT) as they would lead to artifacts. In samples much larger than the largest ultrasound wavelength, however, these unwanted structures are still negligible in amplitude or can be well separated temporally, but for small samples this is no longer the case. As a result, reconstruction methods based on direct echoes like SAFT are difficult to apply. For many industrial applications, the reconstruction is not decisive at all, but only the knowledge of the total volume of process pores (TVPP). It is shown with both experimental and numerical methods, that this TVPP can be estimated from the variation in the B-Scans from various small weld seam models.

Fluidic Ultrasound Generation for Non‐Destructive Testing

Frequency Domain Synthetic Aperture Focusing Technique for Variable-Diameter Cylindrical Components.

Surface Wave Transducer for Ultrasonic Nondestructive Testing of Polymer Components

The thermoacoustic effect and its application in air-coupled testing of composite structures

Development of an Accurate and Robust Air-Coupled Ultrasonic Time-of-Flight Measurement Technique

Micro/nano Acoustofluidics: Materials, Phenomena, Design, Devices, and Applications.

Air-Coupled Broadband Impact-Echo Actuation Using Supersonic Jet Flow

Air-coupled ultrasound using broadband shock waves from piezoelectric spark igniters

High-Frequency Photoacoustic Measurements in Air

Broadband Air-Coupled Ultrasound Emitter and Receiver Enable Simultaneous Measurement of Thickness and Speed of Sound in Solids

Fast acoustic droplet ejection based on annular array transducer

Spatial and Temporal Deep Learning in Air-Coupled Ultrasonic Testing for Enabling NDE 4.0

Acoustic and Optical Characterization of Targeted Ultrasound Contrast Agents

Non-contact detection of the interfacial microdefects in metal/CFRP hybrid composites using air-coupled laser ultrasound

Contactless Fluid Manipulation in Air: Droplet Coalescence and Active Mixing by Acoustic Levitation

Estimation of the Dynamic Focused Ultrasound Radiation Force Generated by an Ultrasonic Transducer

Flexible Pico-Liter Acoustic Droplet Ejection Based on High-Frequency Ultrasound Transducer.

Efficient testing of weld seam models with radii of curvature in the millimeter range using laser ultrasound

Developing Electrostatically Driven Ultrasound Transducer with High Sound Intensity and High Energy Conversion Efficiency

LUFT: A low-frequency ultrasound tomography system designed for lung imaging

Evaluation of Defect Detection in Aluminium, CFRP and Epoxy Resin Plates Using Non-contact Air-Coupled Ultrasonic Waves