Abstract:A recently proposed baseline shaped film cooling hole is numerically investigated on a flat plate at four blowing ratios (M), 0.5, 1.0, 2.0 and 3.0 and two density ratios (DR), 1.2 and 1.5. Results show that there exists an optimal blowing ratio and a best coolant operating condition in the current simulation set. The cooling effectiveness shows insensitivity to changes in density ratio for the same blowing ratio no higher than 1.0. A high density ratio effectively compensates for the negative impacts brought by a higher blowing ratio coolant than the optimal. It is also summarised that a velocity ratio (VR) around 1 should be a division point where the coolant flow behaviour differentiates and thus decides the cooling performance characteristics. Specifically, this paper proposes the idea of the quantification of two-dimensional film cooling performance, through three additional parameters: area-averaged adiabatic cooling effectiveness, standard deviation of adiabatic cooling effectiveness distribution and a defined distortion factor measuring the uniformity of adiabatic cooling effectiveness distribution. Different conclusions concerning the optimal coolant operating condition are drawn based on whether these two-dimensional cooling performance parameters or the commonly employed one-dimensional parameters, centreline and lateral-averaged adiabatic cooling effectiveness, are applied for evaluation. When using one-dimensional parameters, the DR = 1.5 M = 2.0 case is the best coolant operating condition, while using the two-dimensional parameters, the optimal condition changes to DR = 1.5 M = 1.0 and the optimal blowing ratio also changes from 2.0 to 1.0. Besides, the DR = 1.2 M = 3.0 case becomes the worst cooling performance working condition instead of the two M = 0.5 cases. In addition, VR is found to better scale and predict area-averaged cooling effectiveness. Some new information on the uniformity and the variation level of cooling effectiveness distribution under various coolant operating conditions is also revealed. Visualisation of the flow field structures shows that the two-dimensional cooling performance is decided by the offsetting results of the negative and positive influences from the counter-rotating vortex development in lateral, spanwise and streamwise directions.

Theoretical model for two-dimensional film cooling effectiveness distribution prediction

2-D Prediction Method for Multi-Row Film Cooling Effectiveness

Scalar Diffusion Equation-Based Model to Predict 2-Dimensional Film Cooling Effectiveness of a Shaped Hole

Prediction of transonic film cooling using the turbulent viscosity correction method

ON THE RELIABILITY OF RANS TURBULENCE MODELS FOR ENDWALL COOLING PREDICTION

In-Hole Characteristic Interface and Film Cooling Interface Model

Algebraic Anisotropic Eddy-Viscosity Modeling for Application to Turbulent Film Cooling Flows

A machine learning approach to quantify the film cooling superposition effect for effusion cooling structures

Non-Uniform Source Term Model for Film Cooling with the Internal Cross Flow

Conjugate Heat Transfer Analysis of Film Cooling Flows

Numerical Investigation on a Baseline Shaped Film Cooling Hole: One- and Two-Dimensional Cooling Performance

Experimental and numerical study of film cooling with internal coolant cross-flow effects

Assessment of a virtual boundary concept for efficient modeling of turbine film cooling

High Resolution Simulation of Film Cooling with Blowing Ratio and Inclination Angle Effects Based on Hybrid Thermal Lattice Boltzmann Method

Accuracy Assessment of the Sellers Model in Predicting the Multi-Row Film Cooling Performance

Enhancement of Film Cooling Effectiveness Using Dean Vortices

Analysis on the Mechanism of Evolutionary Process of Counter-Rotating Vortex Pair in Film Cooling Based on Hybrid Thermal Lattice Boltzmann Method

Large-Eddy Simulation of Film Cooling with Internal Coolant Crossflow Effects

Full Field Algebraic Anisotropic Eddy Viscosity Model for the Film Cooling Flows

Eckert number application for scaling of heat-mass transfer analogy in transonic film cooling

Trajectory and Effectiveness of Film Cooling in Endwall Crossflow