Abstract:The influence of complicated interaction between the flow field and heat transfer in cooled turbines becomes more and more significant with the increasing turbine inlet temperature. However, classical through-flow methods did not take into account the influence of the interaction caused by air cooling. The aerodynamic design and cooling design of cooled turbines were carried out separately, and the iterations between the aerodynamic design and cooling design led to a long design period and raised the design cost. To shorten the design period and decrease the design cost, this paper proposes a concise aero-thermal coupled through-flow method for the design of cooled turbines, taking into account the influence of the complicated interaction between the flow field and heat transfer in cooled turbines. The governing equations, such as energy equation and continuity equation in classical through-flow method are re-derived theoretically by considering the historical influence of cooling with the same method that deals with viscous losses in this paper. A cooling model is developed in this method. The cooled blade is split into a number of heat transfer elements, and the heat transfer is studied element by element along both the span and the chord in detail. This paper applies the method in the design of a two-stage axial turbine, of which the first stator is cooled with convective cooling. With the prescribed blade temperature limitation and the knowledge of the flow variables of the mainstream at the turbine inlet, such as the total pressure, total temperature and mass flow rate, the convergence of the calculation is then obtained and the properties of the flow field, velocity triangles and coolant requirement are well predicted. The calculated results prove that the aero-thermal coupled through-flow method is a reliable tool for flow analysis and coolant requirement prediction in the design of cooled turbines.

A Novel Model for CFD-Based Throughflow Analysis of Film-Cooled Turbine Blade

Numerical Investigation of the Impact of Wind Turbine Rotor on the Passive Cooler above Nacelle

Aero-Thermal Coupled Throughflow Method With Cooling Model Based On Flow Network Analysis

Aero-thermal Coupled Through-Flow Method for Cooled Turbines with New Cooling Model

Convective Cooling Model for Aero-Thermal Coupled Through-Flow Method

An Aero-Thermal Coupled Throughflow Method For Convective Cooled Turbines

An Aero-thermal Coupled Throughflow Method for Cooled Turbines

Through-Flow Calculation with A Cooling Model for Cooled Turbines

A viscous blade body force model for computational fluid dynamics–based throughflow analysis of axial compressors

Development of an Aero-Thermal Coupled Through-Flow Method for Cooled Turbines

A total three-dimensional evaluation method to analyze the loss mechanism of film cooling on turbine guide vane

Non-Uniform Source Term Model for Film Cooling with the Internal Cross Flow

A Modified Analytical Model to Calculate Temperature Distribution of Gas Turbine Blade and the Cooling Air Required

Numerical Investigation of Film Cooling Effectiveness on a Rotating Turbine Blade Model

Numerical Investigation Of Coolant-To-Mainstream Scaling Parameters With Film Cooling On Pressure And Suction Side Of A Gas Turbine Blade

Film Cooling Modeling of Turbine Blades Using Algebraic Anisotropic Turbulence Models

Development of a Throughflow-Based Simulation Tool for Preliminary Compressor Design Considering Blade Geometry in Gas Turbine Engine

Conjugate Heat Transfer Predictions on Combined Impingement and Film Cooling of a Blade Leading Edge Model

An Enhanced Flow-Thermo-Structural Modeling and Validation for the Integrated Analysis of a Film Cooling Nozzle Guide Vane

NUMERICAL INVESTIGATION OF DIFFERENT TURBULENCE MODELS APPLIED IN COMBINED IMPINGEMENT AND FILM COOLING

Experimental and Numerical Investigations of Shaped Hole Film Cooling with the Influence of Endwall Cross Flow