Abstract:Shell-and-tube evaporators are widely used in desalination, refrigeration, and petrochemical industries. The heat transfer process in spray-type evaporators combines the droplets impingement at the top rows of the bundles and falling film evaporation for the bottom rows, with a transitional region in the center of the bundle. Spray evaporators are a promising alternative to flooded-type shell and tube heat exchangers because they run with significantly lower refrigerant charge amounts. This study presents new data for the spray evaporation of low-GWP refrigerant/oil mixtures on an enhanced tube bundle. The experiments involved R134a (HFC) and R1234ze(E) (HFO) paired with synthetic Polyolester (POE68 and POE220) lubricants. The tests utilized a boiling enhanced tube (re-entrant cavity tube) and were conducted at saturation temperatures of −6.7 °C, 2.2 °C and 10 °C (20°F, 36°F and 50°F), with heat flux varying from 3 to 35 kW/m 2 and oil circulation ratio (OCR) ranging from 0.4 % to 2 %. With the addition of oil, the bundle heat transfer coefficient (HTC) of refrigerant/oil mixtures decreased by 20–50 % at an OCR of 1.2 % and a heat flux of 13.5 kW/m 2 , across the tested saturation temperatures. The average wall superheat across the bundle exhibited at least a 48 % increase for all the refrigerant/oil mixtures tested at an OCR of 1.2 %. The viscosity of the refrigerant/oil mixture showed a limited influence on heat transfer compared to surface tension, mainly because the oil concentrations were quite small. Oil promoted a partial dry-out of the tubes, especially at the bottom of the bundle. Foaming was observed and increased with heat flux and oil concentration. Foam sheets on the tube bundle created an additional barrier for the liquid refrigerant to reach the tube heat transfer surfaces and thus decreased the overall bundle heat transfer coefficient.

Experimental Study of Oil Retention in Microchannel Evaporators and Lubricant Effect on Heat Transfer and Distribution Performances with R32/Pve Mixture

Experimental Investigation on Oil Transport, Heat Transfer and Distribution Performances of R32/oil Mixture in Microchannel Evaporators

Investigating the Thermal-Hydraulic Performance of New Refrigerant Mixtures Through Numerical Simulation of Minichannel and Microchannel Evaporators

Study on Flow Boiling Heat Transfer Characteristics of R161/oil Mixture Inside Horizontal Micro-Fin Tube

Experimental Investigation of Oil Retention and Pressure Drop of R32/PVE Oil Mixture in Compressor Suction Line

Thermophysical Properties of R32/advanced PVE Mixture and Parametric Analysis on Oil Transport Characteristic of Compressor Suction Line

Development of Boiling Flow Pattern Map and Heat Transfer Correlation of R32-oil Mixture Inside a Horizontal Micro-Fin Tube

Stratification and Heat Transfer Characteristics for R32-partially Miscible Oil Mixture Flow Boiling Inside a Micro-Fin Tube

Visualization Study on Oil Retention and Flow Characteristics of R32/PVE Oil in Suction Lines with Different Flow Orientations

Nucleate boiling heat transfer of R-134a and R-134a/POE lubricant mixtures on smooth tube

Effect of oil concentration, viscosity, and surface tension on tube temperature and heat transfer coefficients of R1234ze(E)/oil spray evaporation on an enhanced tube bundle

Influence of Lubricant Oil on Heat Transfer Performance of Refrigerant Flow Boiling Inside Small Diameter Tubes. Part I: Experimental Study

Experimental investigation on the heat transfer performance of falling film evaporation with lubrication oil on horizontal tubes having different structures

Modeling of lubricant retention in suction lines with R32/PVE oil mixture

Flow Condensation Heat Transfer Correlation Development of R32-oil Mixture Inside a Micro-Fin Tube

Experimental research of frictional performance of R410A-oil mixture flow condensation inside a 5 mm internally spiral grooved enhanced tube

Modeling of Lubricant Retention in Suction Lines with R32/PVE Oil Mixture Based on Different Flow Patterns

Oil Presence Effect on Thermodynamic Performance of the Evaporator Working with R290

Flow Resistance Characteristics of R410A-oil Mixture during Evaporation in a Small Diameter Enhanced Tube

Experimental evaluation on flow boiling heat transfer of R290/POE-oil working fluid for absorption refrigeration in smooth horizontal tubes

EXPERIMENTAL INVESTIGATION AND CORRELATION OF TWO-PHASE HEAT TRANSFER OF R410A/OIL MIXTURE FLOW BOILING IN A 5-MM MICROFIN TUBE