Abstract:A supercritical carbon dioxide (S-CO2) and Organic Rankine Cycle (ORC) combined cycle has been considered to fully use the residual heat of a high temperature heat source in this paper. The topping cycle is a S-CO2 recompression cycle, and the bottoming cycle is an ORC with R245fa as the working fluid. Compared with previous studies, the influence of several additional parameters, including the S-CO2 recompression cycle main compressor inlet temperature and pressure and the S-CO2 recompression cycle split ratio, has been conducted. It indicates that the split ratio plays an important role on the S-CO2 recompression cycle, even on the combined cycle. A thermodynamic optimization method which considers the split ratio is proposed to maximum the combined cycle thermal efficiency. By this method, more than 4.1% increment on the thermal efficiency can be attained. INTRODUCTION The supercritical carbon dioxide (S-CO2) is a special kind of CO2 fluid whose temperature and pressure are higher than its critical values (304.13K, 7.38 MPa). The S-CO2 cycle, which uses S-CO2 as the working fluid, is considered to be one of the most promising power generation technologies for the future (Feher, 1968). The S-CO2 cycle has higher efficiency and more compact system and components than conventional power cycles, especially in the high temperature range. Besides, CO2 is easy to obtain and the S-CO2 cycle system has high safety level. It is widely acknowledged that the S-CO2 cycle is applicable for various heat sources, such as the nuclear energy (Moisseytsev and Sienicki, 2009), concentrated solar power (Turchi and Ma, 2012), fuel cell (Xia et al., 2019) and waste heat recovery (Song et al., 2018a). One of the S-CO2 cycle characteristics is that the specific heat capacity of the cold side flow is much higher than that of the hot side in recuperators. For the S-CO2 recompression cycle, the CO2 flow is split to compensate for the specific heat difference in the low temperature recuperator and to further enhance the heat recuperation in the high temperature recuperator. Therefore, the residual heat is decreased and the S-CO2 recompression cycle has higher efficiency than simple recuperated cycle. The S-CO2 recompression cycle has been adopted by National Energy Technology Laboratory (NETL) of U.S. DOE for Supercritical Transformational Electric Power (STEP) program (Lambruschini et al., 2016).

Thermodynamic Optimization on Supercritical Carbon Dioxide Brayton Cycles to Achieve Combined Heat and Power Generation

Performance Analysis and Evaluation of a Supercritical CO2 Rankine Cycle Coupled with an Absorption Refrigeration Cycle

Preliminary Conceptual Exploration about Performance Improvement on Supercritical CO2 Power System Via Integrating with Different Absorption Power Generation Systems

Experimental and Numerical Study on Thermal Hydraulic Performance of Trapezoidal Printed Circuit Heat Exchanger for Supercritical CO2 Brayton Cycle

Thermodynamic Analysis of Coal-Fired Thermal Power Units Coupled S-CO2 Energy Storage System

Influence of Supercritical Carbon Dioxide Brayton Cycle Parameters on Intelligent Circulation System and Its Optimization Strategy

Multi-objective optimization of supercritical CO 2 Brayton cycles for coal-fired power generation with two waste heat recovery schemes

Multi-objective Optimization of Combined Cooling, Heating, and Power Systems with Supercritical CO2 Recompression Brayton Cycle

Performance assessment and system optimization on supercritical CO 2 double-path recompression coal-fired combined heat and power plants with MEA-based post-combustion CO 2 capture

Design optimization and off-design performance analysis of one-dimensional supercritical CO 2 Brayton cycle

Thermo-economic analysis and multi-objective optimization of supercritical Brayton cycles with CO2-based mixtures

Supercritical carbon dioxide cycle thermodynamic and exergoeconomic improvements using a bidirectional coupling strategy

Thermodynamic evaluation and optimization of supercritical CO 2 Brayton cycle considering recuperator types and designs

Thermodynamic Analysis of a Cogeneration System Combined with Heat, Cold, and Electricity Based on the Supercritical CO2 Power Cycle

A Global Optimization Method Synthesizing Heat Transfer and Thermodynamics for the Power Generation System with Brayton Cycle

Design and optimization of waste heat recovery system for supercritical carbon dioxide coal-fired power plant to enhance the dust collection efficiency

Research on Dynamic Modeling of the Supercritical Carbon Dioxide Power Cycle

Study on configuration of gas-supercritical carbon dioxide combined cycle under different gas turbine power

Thermo-Economic Optimization Of Supercritical Co2 Brayton Cycle On The Design Point For Application In Solar Power Tower System

Exergoeconomic analysis and multi-objective optimization of a CCHP system based on SOFC/GT and transcritical CO 2 power/refrigeration cycles

Thermodynamic Analysis and Optimization of a Supercritical Carbon Dioxide (S-CO2) Recompression Cycle Coupled with a Bottoming Organic Rankine Cycle