Abstract:One of the investigation areas regarding the Ultrasonic Non-Destructive Test (UT-NDT) is the development of non-contact technologies like Air-Coupled UT, EMAT or UT generated by Laser. These technologies show several interesting advantages like no couplant needed or their application to the inspection of components with complex geometries and extreme surface conditions (temperature, roughness, radiation...). In the Laser Ultrasonics Techniques (LUS), ultrasound is generated by a pulsed laser that produces a thermal expansion of the surface where it impacts and generates vibrations at ultrasonic frequencies. These vibrations can travel through the inside of the material and its surface; and they are reflected, refracted or diffracted in the defects or discontinuities of the material. The disturbances generated by the interaction of the vibration with the defects are detected in another point of the material using a secondary detection system. Tecnatom is working with LUS technology since 2010, acquiring, installing and optimizing a laboratory system for its implementation in the inspection of metallic materials (aluminum, carbon steel and stainless steel). During this time, several works have been carried out to determine the scope of the technology as: initial study for the characterization of the waves generated by the laser; studies in test blocks without discontinuities to determine the experimental conditions in which ultrasonic disturbances are generated in thermo-elastic and ablative regime; simulations and microstructural studies of the pieces to determine both the structural state and the residual stresses caused by the incidence of the laser; inspection of blocks with artificial reflectors, both superficial and embedded, and set-up techniques to increase the amplitude of the detected signal; optimization of the detection system through the combination of technologies and identification of safety criteria, use and improvement of the system for validation use in industrial environments. In this work, Tecnatom presents the main conclusions of the development carried out to determine the capacities and limitations of the techniques based on Laser Ultrasonics for its application in Non-Destructive Testing for the inspection of metallic components.

Laser ultrasonic techniques for nondestructive testing

Nondestructive Evaluation of Special Defects Based on Ultrasound Metasurface

Differential Two-Wave Mixing Interferometer for Crack Detection in Metallic Structures Based on Laser-Induced Ultrasound

Detection and Quantification of Damage in Metallic Structures by Laser-Generated Ultrasonics

Reference-free Crack Detection and Localization by Nonlinear Laser Ultrasonic.

Quantitative Detection of Surface Defect Using Laser-Generated Rayleigh Wave with Broadband Local Wavenumber Estimation

Detecting features of defect metal based on laser ultrasonic technique

Laser-Induced Full-Matrix Ultrasonic Imaging of Complex-Shaped Objects

A Study of Inner Crack Testing with the Laser Phased Array Method.

Note: an in Situ Method for Measuring the Non-Linear Response of a Fabry-Perot Cavity.

Non-destructive laser-ultrasonic Synthetic Aperture Focusing Technique (SAFT) for 3D visualization of defects

Nondestructive testing of internal defects by ring-laser-excited ultrasonic

Quantitative Detection of Small Crack by Nonlinear Laser Ultrasonics

Time-domain Approach for Ultrasonic Non-destructive Detection Based on Synthetic Aperture Focusing Technique

Width and Depth Gauging of Rectangular Subsurface Defects Based on All-Optical Laser-Ultrasonic Technology

A modified synthetic aperture focusing algorithm used for transmission detection based on laser ultrasonics method

Nondestructive Evaluation of MEMS Devices by Laser Confocal Measurements

Laser generated Ultrasound System (LUS) and its application for the Non-Destructive Testing of metallic components

Nondestructive evaluation with fully non-contact air-coupled transducer-scanning laser Doppler vibrometer Lamb wave system

Non-contact detection of the interfacial microdefects in metal/CFRP hybrid composites using air-coupled laser ultrasound

Optical methods of laser ultrasonic testing technology in the industrial and engineering applications: A review