Abstract:Packaging materials have a great impact on the performance and reliability of light-emitting diodes (LEDs). In this study, we have prepared high performance LED devices through encapsulating LEDs by epoxy materials incorporated with filler powders. A set of evaluation methods have also been established to characterize the reliability of LED devices. No delamination or internal cracking between packaging materials and lead frames has been found for the encapsulated high performance LED devices after the package saturation with moisture and subsequent exposure to high-temperature solder reflow and thermal cycling. Four kinds of inorganic silica fillers, namely, quartz, fused silica, cristobalite, and spherical silica, and one kind of organic filler, that is, spherical silicone powder, were incorporated into the epoxy packaging materials to compare their effects on performance of LED devices. The properties of epoxy packaging materials and LED devices were studied by differential scanning calorimetry (DSC), thermogravimetric analyses (TGA), dynamic mechanical analysis (DMA), thermomechanical analyzer (TMA), ultravioletvisible spectrophotometer (UV-vis), scanning acoustic microscopy (SAM), and scanning electron microscopy (SEM). Except the spherical silicone powder filled epoxy materials, all the other filled systems showed lower equilibrium water sorption content and smaller water diffusion coefficient in both water sorption and moisture sorption tests. The coefficient of thermal expansion (CTE) values were also decreased with the addition of fillers, and the systems filled with quartz, fused, and filled with spherical silica gave the best performance, which exhibited the reduced CTE values both below and above Tg. The results of TGA essentially showed no difference between filled and unfilled systems. The glass transition temperature changed little for all the filled systems, except the one incorporated with spherical silicone. The modulus at room temperature increased with the addition of fillers. The light transmittance of filled epoxy materials varied with fillers after UV and thermal aging.

Systematic Investigation and Characterization of Ag Paste for LED Die Attach

Comparative Study of Die-Attach Materials for LED Die Bonding

A novel thermal conductive Ag2O paste for thermal management of light-emitting diode

Polymer Reinforced Solder Paste for Improving Impact Energy Absorption Capability in Micro LED Laser-Assisted Mass Transfer

Effects of Bonding Materials on Optical–Thermal Performances and High-Temperature Reliability of High-Power LED

Low temperature sintering of MOD assisted Ag paste for die-attach application

Thermal improvement of die attach by using PDMS-grafted particles as filler and Its application in solid state lighting

High Electrical and Thermal Conductivity of Nano-Ag Paste for Power Electronic Applications

Improved Thermal Performance of High-Power Led by Using Low-Temperature Sintered Chip Attachment

Reliability Analysis and Evaluation of Epoxy Resin Adhesive for LED Encapsulation

Characterization of a Hybrid Cu Paste as an Isotropic Conductive Adhesive

Low-Temperature Sinterable Cu@Ag Paste with Superior Strength Driven by Pre-Heating Process

A paste based on Cu@Sn@Ag particles for die attachment under ambient atmosphere in power device packaging

Improvement of high-power LED performance with sintered chip attachment

Application of Nano Silver Sintering Technique on the Chip Bonding for Flip-Chip and Vertical Light Emitting Diodes

Sintering bonding process with Ag nanoparticle paste and joint properties in high temperature environment

Investigating the Performance and Reliability of Au-Sn Bonded Flip-Chip Micro-LEDs

Fabrication Of A Hybrid Paste Consisting Of Microscale Ag-Plated Cu Flakes And Nanoscale Ag Particles And Characterization Of Low-Temperature Sintered Hybrid Paste Joints

The effect of thinner SDS-coated Ag NPs and organic carrier PVAc on properties of low-temperature silver paste

Development of Silver Paste With High Sintering Driving Force for Reliable Packaging of Power Electronics

High-performance Light-Emitting Diodes Encapsulated with Silica-Filled Epoxy Materials.