Abstract:Rapid thermal annealing of arsenic and boron difluoride implants, such as those used for source/drain regions in CMOS, has been carried out using a scanning electron beam annealer, as part of a study of transient diffusion effects. Three types of e-beam anneal have been performed, with peak temperatures in the range 900–1200°C; the normal isothermal e-beam anneals, together with sub-second fast anneals and ‘dual-pulse’ anneals, in which the sample undergoes an isothermal pre-anneal followed by rapid heating to the required anneal temperature in less than 0.5s. The diffusion occuring during these anneal cycles has been modelled using SPS-1D, an implant and diffusion modelling program developed by one of the authors. This has been modified to incorporate simulated temperature vs. time cycles for the anneals. Results are presented applying the usual equilibrium clustering model, a transient point-defect enhancement to the diffusivity proposed recently by Fair and a new dynamic clustering model for arsenic. Good agreement with SIMS measurements is obtained using the dynamic clustering model, without recourse to a transient defect model. Defects remaining in diodes fabricated with the forementioned implants after these anneal cycles have been studied using DLTS techniques. Trap densities for the three types of e-beam anneal are comparable to those for furnace annealed diodes, as are the reverse leakage currents measured (typically 2–5nA for a 0.85mm2 diode at −5V).

The High Electron Dose of Voltage Contrast Inspection for the Detection of Nickel Silicide Piping Defects

Study on Industrial Computed Tomography Detection and Identification of Inclusion Defects in Thick-Wall Polyethylene Pipe Butt Fusion Joint Within Nuclear Power Plant

Detection of Electrical Defects by Distinguish Methodology Using an Advanced E-Beam Inspection System

The detection and investigation of Tungsten-plug voids by electron-beam inspection

The Study And Investigation Of Inline E-Beam Inspection For 28nm Process Development

Investigation and Discovery of the Integration of FEOL Process by Electron Beam Inspections

Transient Scanning Electron Beam Annealing Methods Used to Study Diffusion and Defects in Implanted Silicon

The detection and investigation of poly line leakage by electron-beam inspection

The Study and Investigation of Inline E-Beam Inspection for 28nm Process Window Monitor

Inspection of defects in conductive multi-layered structures by an eddy current scanning technique: Simulation and experiments

Effect of in-line electron beam treatment on the electrical performance of Cu/organic low-k damascene interconnects

Mechanism and Detection of Poly Gate Leakage with Nonvisual Defects by Voltage Contrast Inspection

Method of Imaging and Evaluation for Defect Based on Pulsed Eddy Current

Deconvolution Imaging of Weak Reflective Pipe Defects Using Guided-Wave Signals Captured by a Scanning Receiver

Investigation Of Tungsten Rich Residue Defects Induced By Electron Beam Inspection Post Contact Tungsten Chemical And Mechanical Polish

Modelling and experimental study on pipeline defect characterisations using a pulsed eddy current measurement

Methodology and Application of the Detection of Invisible Defect by Voltage Contrast Inspection

Advanced semiconductor diagnosis by multidimensional electron-beam-induced current technique

The Inspection and Solution of Inline CT Defect for 28NM Process Improvement

High-Speed Inspection Method Fusing Pulsed Eddy Current and Magnetic Flux Leakage

An Online Monitoring Method for High- Temperature Environments Combining Eddy Current Testing and Electromagnetic Acoustic Transducer Techniques