Abstract:Extended defects such as dislocations and grain boundaries have a strong influence on the performance of microelectronic devices and on other applications of semiconductor materials. However, it is still under debate how the defect structure determines the band structure, and therefore, the recombination behavior of electron-hole pairs responsible for the optical and electrical properties of the extended defects. The present paper is a survey of procedures for the spatially resolved investigation of structural and of physical properties of extended defects in semiconductor materials with a scanning electron microscope (SEM). Representative examples are given for crystalline silicon. The luminescence behavior of extended defects can be investigated by cathodoluminescence (CL) measurements. They are particularly valuable because spectrally and spatially resolved information can be obtained simultaneously. For silicon, with an indirect electronic band structure, CL measurements should be carried out at low temperatures down to 5 K due to the low fraction of radiative recombination processes in comparison to non-radiative transitions at room temperature. For the study of the electrical properties of extended defects, the electron beam induced current (EBIC) technique can be applied. The EBIC image reflects the local distribution of defects due to the increased charge-carrier recombination in their vicinity. The procedure for EBIC investigations is described for measurements at room temperature and at low temperatures. Internal strain fields arising from extended defects can be determined quantitatively by cross-correlation electron backscatter diffraction (ccEBSD). This method is challenging because of the necessary preparation of the sample surface and because of the quality of the diffraction patterns which are recorded during the mapping of the sample. The spatial resolution of the three experimental techniques is compared.

Advanced semiconductor diagnosis by multidimensional electron-beam-induced current technique

Electron-beam-induced Current Study of Grain Boundaries in Multicrystalline Si

The characterization of high quality multicrystalline silicon by the electron beam induced current method

Understanding and optimizing EBIC pn-junction characterization from modeling insights

Transient Scanning Electron Beam Annealing Methods Used to Study Diffusion and Defects in Implanted Silicon

Semiconductor characterization by scanning ion beam induced charge (IBIC) microscopy

Detection of Electrical Defects by Distinguish Methodology Using an Advanced E-Beam Inspection System

Investigation of Si Dendrites by Electron-Beam-Induced Current

EBIC INVESTIGATION OF AL GETTERING OF CAST-MULTICRYSTALLINE SILICON

Comprehensive Characterization of Extended Defects in Semiconductor Materials by a Scanning Electron Microscope

Electron-beam-induced current study of hydrogen passivation on grain boundaries in multicrystalline silicon: Influence of GB character and impurity contamination

Electron-Beam-Induced Current Measurements of Thin-Film Solar Cells

Evaluation of the performance correlated defects of metamorphic InGaAs photodetector structures through plane-view EBIC

An insight into optical beam induced current microscopy: Concepts and applications

Characterizations on the Doping of Single-Crystal Silicon Carbide

Carrier Recombination Activities and Structural Properties of Small-Angle Boundaries in Multicrystalline Silicon

Nondestructive Evaluation of Semiconductors by Photoacoustic Imaging with High-Frequency Air Transducer

Identification of localized radiation damage in power MOSFETs using EBIC imaging

Advanced characterization of SiC devices by optical beam induced current (OBIC): Experimental and simulation results

Electron beam induced current in the high injection regime

Use of Electron Beam-Induced Current Technique to Characterize Transport Properties of Narrow-Gap-Energy Materials for IR Detection