Abstract:Estimation of the stress distribution in ferromagnetic components is very important for evaluating the working status of mechanical equipment and implementing preventive maintenance. Eddy current testing technology is a promising method in this field because of its advantages of safety, no need of coupling agent, etc. In order to reduce the cost of eddy current stress measurement system, and obtain the stress distribution in ferromagnetic materials without scanning, a low cost eddy current stress measurement system based on Archimedes spiral planar coil was established, and a method based on BP neural network to obtain the stress distribution using the stress of several discrete test points was proposed. To verify the performance of the developed test system and the validity of the proposed method, experiment was implemented using structural steel (Q235) specimens. Standard curves of sensors at each test point were achieved, the calibrated data were used to establish the BP neural network model for approximating the stress variation on the specimen surface, and the stress distribution curve of the specimen was obtained by interpolating with the established model. The results show that there is a good linear relationship between the change of signal modulus and the stress in most elastic range of the specimen, and the established system can detect the change in stress with a theoretical average sensitivity of -0.4228 mV/MPa. The obtained stress distribution curve is well consonant with the theoretical analysis result. At last, possible causes and improving methods of problems appeared in the results were discussed. This research has important significance for reducing the cost of eddy current stress measurement system, and advancing the engineering application of eddy current stress testing.

Application of Closed Magnetic Circuit Method for Evaluating the Stress Distribution along Depth Direction

Characterization of Magnetic Field in Crack Propagation Stage and Application to Non-Destructive Evaluation

Research on Magnetic Testing Method of Stress Distribution

Estimation of stress distribution in ferromagnetic tensile specimens using low cost eddy current stress measurement system and BP neural network

Multiphysics Structured Eddy Current and Thermography Defects Diagnostics System in Moving Mode.

Numerical Simulation on Magnetic Flux Leakage Testing of the Steel Cable at Different Speed Title

Magnetomechanical Measurements for Nondestructive Evaluation of Failure in Steel Structural Element

Deep Defects Evaluation of Conductive Materials Based on Eddy Current Nondestructive Testing with GMR sensor

Search the Stress Distribution for the Test Magnetic Field

Magnetic Field Aberration Induced by Cycle Stress

Magnetic Testing Method of Residual Stress Distribution by Geomagnetic Excitation

Quantitative Nondestructive Estimation of Deep Defects in Conductive Structures

A Method Based on Measured Boundary Conditions for Reconstructing the Magnetic Field Distribution of an Electromagnetic Mechatronic System

Inspection of defects in conductive multi-layered structures by an eddy current scanning technique: Simulation and experiments

Investigation of Stress Concentration and Microdefect Identification in Ferromagnetic Materials within a Geomagnetic Field

Quantitative Inversion of Stress and Crack in Ferromagnetic Materials Based on Metal Magnetic Memory Method

Method of measuring the stress of ferromagnetic materials based on EMAT and magnetic Barkhausen noise characteristic parameters

Analytical Model for Eddy Current Testing of Thickness of Multi-layered Structures and Experimental Verification

A numerical simulation method of residual magnetic field signals for evaluating deformation-induced stress concentration in ferromagnetic materials

Prediction of Inhomogeneous Stress in Metal Structures: A Hybrid Approach Combining Eddy Current Technique and Finite Element Method

Numerical Simulation of Electromagnetic Nondestructive Testing Technology for Elasto–Plastic Deformation of Ferromagnetic Materials Based on Magneto–Mechanical Coupling Effect