Abstract:A super high-head Francis turbine with a gross head of nearly 700 m was designed with computational fluid dynamics (CFD) simulation and laboratory tests. Reduced-scale (1:3.7) physical and numerical models of the real-scale prototype were created to investigate the hydraulic performance. According to the CFD analysis, a strong rotor–stator interaction (RSI) between guide vanes and runner blades is observed as a result of the high-speed tangential flow towards runner created by the super high water head as well as the small gaps between the radial blades. At the designed best efficiency point (BEP), there is no significant flow recirculation inside the flow passage and minor loss occurs at the trailing edge of the stay vanes and guide vanes. Maximum velocity is observed at runner inlets due to flow acceleration through the narrow passages between the guide vanes. The elbow-shaped draft tube gradually decreases the flow velocity to keep the kinetic energy loss at a minimum. The laboratory test was conducted on a reduced-scale physical model to investigate the pressure pulsations and guide vane torque (GVT) under variable-discharge configurations, which are key concerns in the design of a high head turbine. Pressure sensor networks were installed at the inlet pipe, vaneless space and draft tube, respectively. The most intense pressure variation occurs at the inlet pipe and elbow at 0.04–0.2 GVOBEP and 1.5–1.8 GVOBEP with a low frequency about 0.3 times of the runner frequency, while the vibration in vaneless zone performs stable with the blade passing frequency caused by RSI. The GVT shows a declining trend and then keeps stable as GVOs increases at synchronized condition. For the misaligned conditions, the torque of adjacent guide vanes differs a lot except at the synchronous angle and maximum absolute value at least doubles than the synchronized condition.

Experience Measurement of Winter-Kennedy Method on Low Head Tubular Turbine Units

Numerical estimation of prototype hydraulic efficiency in a low head power station based on gross head conditions

Turbine Efficiency Test on a Large Hydraulic Turbine Unit

The efficiency test research on 1# unit of Xiaolangdi hydropower station

Research and Analysis on Model Measurement and Prototype Operation of Large-Scale Kaplan Turbine

Evaluation of the Influence of Upstream Flow on the Energy Characteristics of a Giant Kaplan Turbine

Evaluation of the prototype performance of Wanjiazhai Francis turbine with flow pattern analysis

Hydraulic Characteristics Analysis of a Bulb Tubular Turbine Based on the CFD Simulation and Model Test

Investigating the Performance of a Super High-head Francis Turbine under Variable Discharge Conditions Using Numerical and Experimental Approach

Numerical Simulation And Experimental Study Of The Pressure Fluctuation In Water Turbines

Investigation on Hydraulic Characteristics of a Model and Prototype Bulb Turbine Based on Similarity Criteria

Numerical Analysis of Coriolis Effect on Low-Head Hydraulic Turbines

Analysis of Energy Dissipation in Allowable, Restricted and Prohibited Operating Areas of Wanjiazhai Francis Turbine

Design of Pressure Fluctuation Measurement System for Hydro-Turbine Model Test

Establishment of correlation for the pressure fluctuations on the low-head Francis turbine in the draft tube cone from the model test

Development of Numerical Performance Test Stand for A Kaplan Turbine

Coarse Water in Low-Pressure Steam Turbines

Hydraulic performance optimization of bidirectional tidal power turbine

Numerical Simulation of the Performance of a Low-Head Prototype Kaplan Turbine

Numerical and Experimental Analysis of the Hydraulic Performance of a Prototype Pelton Turbine

New Method on Pumpturbine Characteristic Description and Its Engineering Applications