Abstract:A 600-700GHz SIS mixer with the twin-junction tuning circuit has been designed and fabricated [1] The surface impedance of thin-film superconducting microstrip lines, based on Mattis-Bardeen theory [2], is included in the optimization of RF impedance matching. The receiver noise temperature measured in the frequency range of 630-660GHz is below 200K and the lowest receiver noise temperature of 181K is achieved at 656GHz. The FTS response of the SIS mixer shows a good RF coupling from 600GHz to 700GHz. Both the noise performance and the FTS response can be quantitatively described by numerical results using the quantum theory of mixing. Some detail considerations on the mixer model calculation, such as spreading inductance around the junction tuning structure and mixer's embedding impedance, are discussed. Introduction Nb-based superconductor-insulator-superconductor (SIS) mixers have been used very successfully in sub-mm wavelength detection. Their receiver noise temperature has reached to three times the quantum limit, —3 hfrkB, below the junction's gap frequency. However, at high frequency bands, Nb SIS mixers need to be designed carefully because the photon energy is close to or higher than the gap energy of Nb, A-1.4meV. When the frequency band covers the gap frequency of Nb, —670GHz, the RF loss of Nb superconducting transmission lines increases dramatically and the surface impedance has strong frequency dependence. Usually, the RF properties of a superconducting transmission line can be described by the Mattis-Bardeen theory [2] in good accuracy. From results reported so far [4-9], the best receiver noise temperature is close to 5 hi7kB in the band of 600-700GHz. Despite of the input loss contributed by the experimental setup, some other properties of SIS mixers should be taken into account. In this paper, we characterize the performance of a 600-700GHz mixer by comparing the experimental and simulated results.

An SIS-mixer-based Amplifier for Multi-Pixel Heterodyne Receivers

Microwave Amplification Based on Quasiparticle SIS Up and Down Frequency Converters

Characterization of a low-noise superconductor–insulator–superconductor-based microwave amplifier with local oscillator phase-adjusting architecture

Novel Millimeter-Wave Power Combining Utilizing Wafer Level Packaging Technology

Investigation of SIS Up-Converters for Use in Multi-pixel Receivers

Development of an SIS Mixer-Based Low-Noise Amplifier Amenable to Josephson Oscillator Pumping

A 27 - 57 GHz Down-conversion Mixer with Bulk Injection Technique

A 385-500 GHz Low Noise Superconductor-Insulator- Superconductor Mixer for ALMA Band 8.

Design and Development of SIS Mixers for ALMA Band 10

Performance Characterization of a 600-700 GHz SIS Mixer

Development of a Low-power Consumption Cryogenic MMIC LNA for Immediate Connection with an SIS Mixer

Superconducting Receiver Technologies Supporting ALMA and Future Prospects

Experimental Study of a Planar-Integrated Dual-Polarization Balanced SIS Mixer

Planar Superconductor-Insulator-Superconductor Mixer Array Receivers for Wide Field of View Astronomical Observation

A Compact Superconducting Heterodyne Focal Plane Array Implemented with HPI (hybrid Planar Integration) Scheme

Terahertz high-sensitivity SIS mixer based on Nb-AlN-NbN hybrid superconducting tunnel junctions

Development of a Low-Power Cryogenic MMIC HEMT Amplifier for Heterodyne Array Receiver Application

Temperature-dependent Performances of Nb SIS Mixers at Millimeter and Submillimeter Wavelength Microwave and Millimeter Wave Technology

Development of Superconducting Devices Supporting Radio Astronomy.

Three Quanta Sensitivity Superconductor–Insulator–Superconductor Mixer for the 0.78–0.95 THz Band

Development of a 385–500 GHz Sideband-Separating Balanced SIS Mixer