Abstract:A 600-700GHz SIS mixer with the twin-junction tuning circuit has been designed and fabricated [1] The surface impedance of thin-film superconducting microstrip lines, based on Mattis-Bardeen theory [2], is included in the optimization of RF impedance matching. The receiver noise temperature measured in the frequency range of 630-660GHz is below 200K and the lowest receiver noise temperature of 181K is achieved at 656GHz. The FTS response of the SIS mixer shows a good RF coupling from 600GHz to 700GHz. Both the noise performance and the FTS response can be quantitatively described by numerical results using the quantum theory of mixing. Some detail considerations on the mixer model calculation, such as spreading inductance around the junction tuning structure and mixer's embedding impedance, are discussed. Introduction Nb-based superconductor-insulator-superconductor (SIS) mixers have been used very successfully in sub-mm wavelength detection. Their receiver noise temperature has reached to three times the quantum limit, —3 hfrkB, below the junction's gap frequency. However, at high frequency bands, Nb SIS mixers need to be designed carefully because the photon energy is close to or higher than the gap energy of Nb, A-1.4meV. When the frequency band covers the gap frequency of Nb, —670GHz, the RF loss of Nb superconducting transmission lines increases dramatically and the surface impedance has strong frequency dependence. Usually, the RF properties of a superconducting transmission line can be described by the Mattis-Bardeen theory [2] in good accuracy. From results reported so far [4-9], the best receiver noise temperature is close to 5 hi7kB in the band of 600-700GHz. Despite of the input loss contributed by the experimental setup, some other properties of SIS mixers should be taken into account. In this paper, we characterize the performance of a 600-700GHz mixer by comparing the experimental and simulated results.

Investigation of SIS Up-Converters for Use in Multi-pixel Receivers

An SIS-mixer-based Amplifier for Multi-Pixel Heterodyne Receivers

Observation of Frequency Up-Conversion Gain in SIS Junctions at W Band

A 27 - 57 GHz Down-conversion Mixer with Bulk Injection Technique

Digitally Assisted IIP2 Calibration for CMOS Direct-Conversion Receivers

Characterization of a low-noise superconductor–insulator–superconductor-based microwave amplifier with local oscillator phase-adjusting architecture

A 0.1-1.9Ghz 65nm CMOS Variable-Gain Mixer-First Receiver with DSA and Noise-Shaping TIA.

Microwave Amplification Based on Quasiparticle SIS Up and Down Frequency Converters

Planar-integration of Arrayed SIS Receiver Frontends

A Novel Mm-Wave SIS Mixer Comprising Series-Connected Junction Array and On-Chip Bias-T

Planar Superconductor-Insulator-Superconductor Mixer Array Receivers for Wide Field of View Astronomical Observation

A 2.1–2.5 GHz high linearity and low noise down-conversion active mixer

Experimental Study of a Planar-Integrated Dual-Polarization Balanced SIS Mixer

Performance Characterization of a 600-700 GHz SIS Mixer

An InP-Based Mid-Wave Infrared Up-Converter Utilizing Cascade Carrier Transportation

A Quantum-Limited Submillimeter Mixer with an Inhomogeneous Distributed SIS Junction Array

A Compact Superconducting Heterodyne Focal Plane Array Implemented with HPI (hybrid Planar Integration) Scheme

On-Wafer Cryogenic Characterization Technique of an SIS-Based Frequency Up and Down Converter

Fabrication of Planar-Integrated SIS Mixer Circuits with Improved Uniformity and Yield

A GaAs-based Up-Converter for Mid-Infrared Detection Utilizing Quantum Cascade Transport

Terahertz high-sensitivity SIS mixer based on Nb-AlN-NbN hybrid superconducting tunnel junctions