Abstract:In this investigation, the cooling characteristics of mini-channel heat sink with the water-based nano-phase change material emulsions are examined experimentally. The n-eicosane nanoparticles and the pure water are considered as the as the phase change material and base fluid, respectively. The fluid flow and convection heat transfer in the mini channel heat sink are studied at different parameter ranges: the volumetric flow rate varied from <math>Q˙</math> = 60 cm3 min−1 to 600 cm3 min−1, three values of the heat flux imposed on the bottom wall of the heat sinks including <math>qh″</math> = 3.2 W cm−2, 3.95 W cm−2, and 4.78 W cm−2, and the mass fraction of n-eicosane nanoparticles varied from ωpcm = 0%–10%. The influences of these parameters on the friction factor, wall temperature, heat transfer effectiveness, Nusselt number, figure of merit, coefficient of performance, and thermal resistances are investigated. It is concluded that for the low volumetric flow rate and the heat fluxes of heat flux of 3.20 W cm−2, 3.95 W cm−2, and 4.78 W cm−2, using the n-eicosane nanoparticles with larger values of mass fraction is more proper to decrease the wall temperature. For low value of heat flux, the value of the convective heat transfer effectiveness is larger than unity for most values of Reynolds number. The maximum figure of merit index of 1.098 can be achieved at the Reynolds number of 1381, the heat flux of 4.78 W cm−2, and the mass fraction of 2%. The figure of merit index is decreased with boosting the mass fraction of n–eicosane particles. The figure of merit index is decreased about 44% with boosting the mass fraction of n–eicosane particles from 2% to 10% for the heat flux of 3.20 W cm−2. The usage of n-eicosane nanoparticles with the concentration of 2% results in the lower thermal resistances in comparison to the case of pure water. The difference between the thermal resistances for various mass fractions of n-eicosane nanoparticles decreases as the heat flux increases.

An Experimental Study on the Thermosiphon Loop with a Microchannel Heat Sink Operating with the Phase Change Emulsion

Experimental Investigation on the Heat Transfer Performance and Evaporation Temperature Fluctuation of a New-Type Metal Foam Multichannel Heat Pipe

Experimental Study on an Thermosyphon Loop with Bubble Pump Effect

An Experimental Study of Microchannel and Micro-Pin-Fin Based On-Chip Cooling Systems with Silicon-to-Silicon Direct Bonding.

Experimental Study and Taguchi Analysis on LED Cooling by Thermoelectric Cooler Integrated with Microchannel Heat Sink

Preparation and Characterization of Phase Change Microcapsule Emulsion for Thermal Energy Storage and Transportation

Experimental study on thermal performance of water/nano-phase change emulsion through a mini- and micro-channel stacked double-layer heat sink

Experimental study on a loop thermosyphon with microencapsulated phase change material suspension

Cooling performance of mini-channel heat sink with water-based nano-PCM emulsion-An experimental study

Heat transfer enhancement in a loop thermosyphon with microencapsulated phase change material suspension

Convective heat transfer of nano-encapsulated phase change material suspension in a divergent minichannel heatsink

Experimental investigation on the heat transfer characteristics of loop thermosyphon with a micro-channel evaporator under low heat flux

Experimental study of the hydraulic and thermal performances of nano-sized phase change emulsion in horizontal mini-tubes

Experimental study in thermal expansion devices of phase-change material coupled to vapor chamber with gradient wettability wick

Experimental and Numerical Investigations on a Phase Change Material Based Heat Sink with Symbiotically Joined Heat Pipe

Thermal design of a novel heat sink cooled by natural convection with phase transition in the series loop

Experimental Study On Cpu Cooling System Of Closed-Loop Two-Phase Thermosyphon

Heat transfer performance by forced convection of microencapsulated phase change material-latent functional thermal fluid flowing in a mini-channels heat sink

Experiments on the Transient Heat Transfer of Minichannel Heat Sink under High Heat Flux Density in an Enclosed Loop

A numerical simulation validated experimentally for thermally developing convection characteristics of a phase change nanofluid flow in a circular tube

Experimental study on single-phase hybrid microchannel cooling using HFE-7100 for liquid-cooled chips