Abstract:Water ingress into the primary circuit is generally recognized as one of the severe accidents with potential hazard to the modular high temperature gas-cooled reactor, which will cause a positive reactivity introduction with the increase of steam density in reactor core to enhance neutron slowing-down, also the chemical corrosion of graphite fuel elements and the damage of reflector structure material. The increase of the primary pressure may result in the opening of the safety valves, consequently leading the release of radioactive isotopes and flammable water gas. The research on water ingress transient is significant for the verification of inherent safety characteristics of high temperature gas-cooled reactor. The 200MWe high temperature gas-cooled reactor (HTR-PM), designed by the Institute of Nuclear and New Energy Technology of Tsinghua University, is exampled to be analyzed in this paper. The design basis accident (DBA) scenarios of double-ended guillotine break of single heat-exchange tube (steam generator heat-exchange tube rupture) are simulated by the thermal-hydraulic analysis code, and some key concerns which are relative to the amount of water into the reactor core during the blow-down transient are analyzed in detail. The results show that both of water mass and steam ratio of the fluid spouting from the broken heat-exchange tube are affected by break location, which will increase obviously with the broken location closing to the outlet of the heat-exchange tube. The double-ended guillotine rupture at the outlet of the heat-exchange will result more steam penetrates into the reactor core in the design basis accident of water ingress. The mass of water ingress will also be affected by the draining system. It is concluded that, with reasonable optimization on design to balance safety and economy, the total mass of water ingress into the primary circuit of reactor could be limited effectively to meet the safety requirements, and the pollution of radioactive isotopes releasing to the secondary circuit during the blow-down transient will be prevented.

INTEGRITY ANALYSIS OF MAIN PUMP SHAFT SEAL UNDER ACCIDENTS INDUCED BY SBO FOR CANDU

Failure Analysis on Speed Reducer Shaft of Sluice Gate in Nuclear Power Plant

Failure Analysis on the O-ring of Radial Thrust Bearing Room of Main Pump in a Nuclear Power Plant

Study on the Four-Quadrant Homologous Characteristic and Two-Phase Flow Head Degradation of a Reactor Coolant Pump

Seismic Analysis on Canned Motor Pump Used in Nuclear Power Generating Station

THE CMT SIMULATION ON THE LARGE IMPASSIVE PWR WITH RELAP 5

Analysis on blow-down transient in water ingress accident of high temperature gas-cooled reactor

Thermo-Mechanical Analysis of Instrumentation Guide Tube Failure During a Severe Accident in a Nordic Boiling Water Reactor

The Sensitivity Analysis of Passive Containment Cooling System During Design Basis Accidents

Thermal-hydraulic characteristics analysis of unprotected accident and protection control strategy for helium-xenon cooled reactor system

Development of Mechanical Seal for Containment Spray Pump of PWR Nuclear Power Plant

Transient Characteristics of Typical Design Basis Accidents in Integrated Small Reactor NHR200-II Using RELAP5 Model

Force and moment analysis of pipe system for double end break loss of coolant accident in primary loop of PWR

Analysis of AP1000 Containment Passive Cooling System During a Loss-of-coolant Accident

Analysis and Referential Significance of a Breakdown Accident of the Main Feed Water Pump in a 350 MW Supercritical CFB Boiler

Integrity Analysis of Inertial Flywheel of Primary Circulation Pump

Analysis of the Accelerator-Driven System Fuel Assembly during the Steam Generator Tube Rupture Accident

Safety Analysis in VVER-1000 Due to Large-Break Loss-of-Coolant Accident and Station Blackout Transient Using RELAP5/SCDAPSIM/MOD3.5

Research on transient hydraulic characteristics of the whole process of reactor coolant pump under shaft stuck accident

Thermal Hydraulic Analysis of China Spallation Neutron Source Target System Under Abnormal Situations

Simulation study on HPR1000-based suppressive containment system under typical accidents