Abstract:Recently, the construction of stable superhydrophobicity on metallic wetting surfaces has gained increasing attention due to its potential wide applications. In this paper, we propose an economic fabricating method, which not only is suitable for metallic planar surfaces, but also could be applied onto cylindrical inner surfaces. It mainly involves two steps: etching micro-concaves by a movable mask electrochemical micromachining (EMM) technique and fabricating nanopillars of ZnO by a hydrothermal method. Then the influences of surface morphology on the static and dynamic behaviors of water droplets are investigated. The energy loss during impact on the surfaces is quantified in terms of the restitution coefficient for droplets bouncing off the surfaces. For hierarchical structures with excellent superhydrophobicity (contact angle :,approximate to 180 degrees and sliding angle <= 1 degrees), the droplet bounces off the surface several times, superior to the droplet's response on single nanopillars (contact angle :,approximate to 165.8 degrees and sliding angle :,approximate to 6.29 degrees) where droplet bounces off only for limited a number of times, and even far better than the dynamics of a liquid droplet impinging on microstructures (contact angle :,approximate to 132.1 degrees and sliding angle >90 degrees) where droplet does not rebound and remains pinned. The highest elasticity is obtained on the hierarchical surface, where the restitution coefficient can be as large as 0.94. The fabricating method is then applied onto the cylindrical inner surface and the wetting behavior is confirmed to be consistent with the planar surface. This method, which can be generalized to any kind of solid electroconductive metal or other surfaces with different shapes, could find wide practical applications in self-cleaning surfaces, chemical industry, microfluidic devices, mechanical engineering and aviation. (C) 2014 Elsevier B.V. All rights reserved.

Fabrication of Super-hydrophobic Surfaces and Studies of Water Flow in Super-hydrophobic Micro-tubes

Water Slip Flow in Superhydrophobic Microtubes Within Laminar Flow Region

Experimental and theoretical investigations on the flow resistance reduction and slip flow in super-hydrophobic micro tubes

Fabrication of Super-hydrophobic Surfaces for Microfluidic Chips

Fabrication of Air-Permeable Superhydrophobic Surfaces with Excellent Non-Wetting Property

Experimental Research on Friction-Reduction with Super-Hydrophobic Surfaces

Fabrication of Hierarchical Structures for Stable Superhydrophobicity on Metallic Planar and Cylindrical Inner Surfaces

Fabrication of Superamphiphobic Surface with Hierarchical Structures on Metal Substrate

Thermal-hydraulic Performance Enhancement Analysis of Microtube with Superhydrophobic Surfaces

Fabrication of Superhydrophobic Surfaces on Stainless Steel Mesh Substrates Via Electro-brush Flow Plating Technology

Fabrication and Condensation Characteristics of Metallic Superhydrophobic Surface with Hierarchical Micro-Nano Structures

Fabrication and drag reduction of superhydrophobic surface on steel substrates

Revisiting the Fabrication of Superhydrophobic Aluminum Surfaces and Their Use As Soft Substrates for Droplet Manipulation

Fabrication of superhydrophobic surfaces on aluminum substrates via electrochemical etching and re-deposition

DRAG REDUCTION IN TURBULENT FLOWS OVER SUPERHYDROPHOBIC SURFACES WITH MICRO-NANO TEXTURES

Fabrication of Super-Hydrophobic Surface on Stainless Steel Using Chemical Etching Method

A simple method to fabricate the different extents of superhydrophobic surfaces

Tribological Performance of Microstructured Surfaces with Different Wettability from Superhydrophilic to Superhydrophobic

Fabrication of Superhydrophobic Surface with Different Metal Films on Aluminum Alloy

The Fabrication of Unwettable Superhydrophobic Surfaces by Reactive Wetting of AgCuTi into an AAO Template

A Novel Fabrication of Superhydrophobic Surfaces on Aluminum Substrate