Abstract:NHR200-II is a 200 MW nuclear heating reactor. The integrity of the fuel assembly should be ensured during the normal operations and design basis accidents. In the latter cases (e.g. earthquake), its deformation or damage should not prevent the insertion of control rods to shut down the reactor. Meanwhile, during the operating time, there are two aspects that attention should be paid, (i) the mechanical performance of internal core materials might be worsened by the increase of burnup and (ii) dynamic loads involving hydraulic erosion, flow-induced vibration might damage the assemblies. Therefore, the investigation of the dynamic characteristics of the fuel assembly with consideration of burnup effects is necessary. The fuel rod with pellets and cladding was approximated by the beam elements with a circular cross-section applied with calibrated material properties. Connector elements were used to replace the three-arc springs and dimples on the grid and thus simplify the geometry of the spacer grid. The agreements between the detailed and simplified models indicate the equivalence of these two methods. Then two simulations were performed to evaluate the dynamic characteristics of NHR200-II fuel assembly at the beginning of life. The modal simulation of the fuel bundle and channel suggests that the channel could be assumed stationary to the fuel bundle during the dynamic analysis. The seismic simulation conducted in the specific boundary conditions indicates that the integrity of spacer grids can be guaranteed and there was no buckling of the gird. No permanent deformation of the channel was observed, and its relative displacements were sufficiently small to ensure the insertion of control rods. Finally, burnup effects on the structural behavior of the fuel rod are discussed. The initial conditions of NHR200-II fuel assembly and its material properties at different burnup times are provided by referring to two irradiated tests. Various sensitivity analyses had been conducted to evaluate the effects of material properties and pellet-cladding interaction on the resulting failure limit and stiffness of the fuel rod.

Disassembly Simulation of Main Pipe Insulation Layer of Nuclear Power Plant Pressure Vessel Based on DELMIA

Model Simplification of Nuclear Power Plant for Power System Dynamic Simulation

Experimental and Numerical Investigation on the Seismic Behavior of above Ground High Density Polyethylene Pipe in Nuclear Power Plant

A Simulation Method for Nuclear Power Plant with High-Temperature Gas-Cooled Reactor

Research and Analysis on the Optimization of the Preventive Disassembly Inspection Intervals of Important Wedge Gate Valves in the Primary Cooling System of CPR1000 Nuclear Power Plant

Pre-conceptual Design Assessment of DEMO Remote Maintenance

Theoretical Investigations On Water Condensation In Main Steam Pipe

Simulation of Dynamic Characteristics of NHR200-II Fuel Assembly

Simulation and experimental studies of induction heating during the partial upset-extrusion of a nuclear main pipe

SIMULATION AND ANALYSIS ABOUT WORN-OUT ON CONNECTING PIPE OF LOW-PRESSURE REHEATER FOR A BOILER OF 600 MW UNIT

Effective Design of Submarine Pipe-in-pipe Using Finite Element Analysis

Cfd Simulation Of Thermal-Hydraulic Characteristics Of Water Seal Structure In Pwr Pressurizer

3D Fluid-Solid Coupling Simulation for Plate-Type Nuclear Fuel Assemblies under the Irradiation Condition

A review of pipe cutting, welding, and NDE technologies for use in fusion devices

Virtual-reality simulation of operations and radiation dose for nuclear ;power plant

Simulation of the Airborne Radioactive Substance Distribution and Monitoring of Coolant Leakage in a Typical Nuclear Reactor Containment

The simulation design of eddy current inspection on the control rod of nuclear power plant

Numerical Simulation of Three Dimensional Internal Flow of A Pwr Reactor

Development of CFD Methodology for Investigating Thermal-Hydraulic Characteristics in a PWR Dome

Preliminary Design and Assessment of a Heat Pipe Residual Heat Removal System for the Reactor Driven Subcritical Facility

Integrated Virtual Assembly Environment and its application in ship piping layout