Abstract:Composite T-joints bear low-velocity impact in service. The characteristics of their impact response and residual tensile performance are crucial to structural safety but have not been researched in sufficient detail. This study applies the Z-pin pre-hole insertion process in concert with two fillet radii to manufacture four types of carbon fiber reinforced plastics (CFRP) T-joints. The joints were then characterized by using robust low-velocity impact tests at different energies as well as post-impact quasi-static tensile tests. The results show that increasing the size of the deltoid improved the impact resistance of the joints but the deltoid itself was more vulnerable to damage, which reduced its influence on the residual tensile performance of the joints with increasing impact energy. The Z-pin reinforcement in the non-impact region had a limited influence on the low-velocity impact resistance, while its influence on the residual tensile performance of the T-joints was positively correlated with the degree of damage to them after impact. Moreover, the difference in influence between the deltoid and the Z-pin on the structural properties and damage tolerance of the T-joints was closely related to their respective reinforcement mechanisms, and can contribute to the lightweight design of the T-joint. We also used infrared thermography to observe the evolution of damage to the T-joints during the loading process. The significant fracture of the joint was predicted successfully by comparing different infrared characteristics.

Experimental Investigation into the Failure of CFRP T-joints under Ice Impact and Quasi-static Loadings

Experimental Investigation into Influences of Z-pin and Deltoid on Structural Properties and Damage Tolerance of CFRP T-joints

Hail Impact Responses and Residual Tensile Properties of CFRP T-joints

Experimental study on dynamic behavior of CFRP-to-steel interface

Dynamic Behavior of CFRP-Strengthened Reinforced Concrete Beams Without Stirrups under Impact Loading

Artificial hail ice impact damage of laminated composite T-joint with stitching reinforcement

Experimental Study of Dynamic Tensile Properties of CFRP、GFRP Laminates under Shock Stress Waves

Low-velocity impact behavior and residual tensile strength of CFRP laminates

An experimental study of the dynamic responses of carbon fiber reinforced polymer composite laminates subjected to ice impact

Failure of Single Hat-Shaped Thin-Walled Tubular Composite T-joints under Impact Loading

Experimental Study of Dynamic Mechanical Properties of Composite Laminate Plate under the Impact Loading

Experimental Investigation of the Double Impact Position Effect on the Mechanical Behavior of Low-Velocity Impact in CFRP Laminates

Experimental Analysis and Prediction of CFRP Delamination Caused by Ice Impact

Experimental investigation on dynamic compressive properties of SHCC after freeze-thaw cycles

Investigations of ice impact damage and residual performance of 3D angle-interlock woven composites based on in-situ sampling

Experimental Investigation of Low-Velocity Impact Behavior and CAI on Composite Laminates by Discrete Interleaved Toughening

On the mechanical performance and damage evolution of rivet-bonded composite T-joint under three-point bending: A combined experimental and numerical study

Failure Characteristics of Composite Metallic Foam Core Hat-Shaped Tubular T-joints under Static and Impact Loading

Experimental investigation into transverse crashworthiness of CFRP adhesively bonded joints in vehicle structure

Numerical Simulation on Fracture Mechanisms of CFRP with Barely Visible Impact Damage by Hail Impact

Damage and Failure Analysis of Composite Stiffened Panels under Low-Velocity Impact and Compression after Impact