Abstract:In this study, the effect of residual stresses on the free vibration response of structural steel sheets is investigated for the purpose of structural health monitoring. Residual stresses are introduced into the structural steel sheet through a prestressing process known as dimple formation. The material properties of a rimmed steel disk were initially obtained via experiment. A dimple is then formed, corresponding to an experimentally obtained drop-hammer impact velocity of V = 3.11 m/s for a drop angle of 30°. The material properties and impact velocity are later imported into ABAQUS finite element analysis (FEA) simulation package to obtain the structural deformation before and after elastic recovery via the Dynamic Explicit Analysis. The numerically obtained residual stresses, remained after elastic recovery and caused by dimple formation, are then used as an initial prestress condition for the subsequent eigenfrequencies of free vibration. To do so, a four-step FEA structural model is developed to explore the vibration response of structural steel sheets under three conditions: (1) no dimple exists; (2) dimple exists but residual stresses are ignored intentionally; (3) both dimples and residual stresses exist. The natural frequency outcomes are then experimentally validated by using laser interferometry technique (LIT). Finally, the effect of incremental mass removal on natural frequencies in the steel sheets with or without dimple is experimentally investigated using an audio recorder. Unless the material properties are not readily available, the proposed structural model is entirely independent from any experimentation. The developed structural model demonstrates how superposition of the prestress field over the indicative stress field for each vibration mode of interest can be used to reliably predict vibration outcomes. The model can be used as a structural/mechanical design tool to explore the existence of residual stresses in steel sheets.

Critical Natural Frequency: an Improved Empirical Effectiveness Criterion in Vibration Stress Relief of Rectangle Welded Plates

Research on High-Frequency Vibratory Stress Relief of Small Cr12mov Quenched Specimens

Mechanism and Experimental Research on High Frequency Vibratory Stress Relief

Improvement Of Cyclic Void Growth Model For Ultra-Low Cycle Fatigue Prediction Of Steel Bridge Piers

Vibration Stress Relief Mechanism and Its Impact on Fatigue Life

Vibration Stress Relief of DH 36 Rectangle Welded Plates

Improved Ultra-Low Cycle Fatigue Fracture Models for Structural Steels Considering the Dependence of Cyclic Damage Degradation Parameters on Stress Triaxiality

A combined computational and experimental study on vibration stress relief for large welded DH36 steel tube

The Effectiveness Evaluation of 314L Stainless Steel Vibratory Stress Relief by Dynamic Stress

Variation of structural damping and effectiveness evaluation of vibratory stress relief

Vibratory Stress Relief of Welded Structure in China

Reduce the Residual Stress of Welded Structures by Post-Weld Vibration

Influence of Vibration Stress Relief (vsr) on the Residual Stress and Microstructure in Welded Plate of Dh36 Low Alloy High Strength Steel

The Application of Vibratory Stress Relief to Energy Engineering

Prediction of weld induced residual stress reduction by vibration of a T-joint using finite element method

The Influence of Vibratory Treatment on the Fatigue Life of Welds: A Comparison with Thermal Stress Relief

Experimental and numerical studies on the vibration-based structural health monitoring of dimpled steel sheets with residual stresses

Experimental and simulation analysis on the effect of vibratory stress relief on impact toughness of Q345/316 L dissimilar steel welded joints

Quantification of CTOD fracture toughness in welded joints to evaluate the efficacy of vibration stress relief compared to thermal stress relief

Residual Stress Relaxation in the Laser Welded Structure after Low-Cycle Fatigue and Fatigue Life: Numerical Analysis and Neutron Diffraction Experiment

A Method for Estimation of Critical Stress Intensity Factor for Welded Sheet