Abstract:Direct contact condensation (DCC) is a phenomenon observed when steam interacts with subcooled water, exhibiting higher heat and mass transfer rates compared to wall condensation. It has garnered significant interest across industries such as nuclear, chemical, and power due to its advantageous characteristics. In the context of pressure-relief tanks, understanding and optimizing the DCC process are critical for safety and efficiency. The efficiency of pressure-relief tanks depends on the amount of steam condensed per unit of time, which directly affects their operational parameters and design. This study focuses on investigating the direct gas–liquid contact condensation process in pressure-relief tanks using computational fluid dynamics (CFD). Through experimental validation and a sensitivity analysis, the study provides insights into the influence of inlet steam parameters and basin temperature on the steam plume characteristics. Furthermore, steady-state and transient calculation models are developed to simulate the behaviour of the pressure-relief tank, providing valuable data for safety analysis and design optimization. There is a relatively high-pressure area in the upper part of the bubble hole of the pressure-relief tube, and the value increases as it is closer to the holes. The steam velocity in the bubbling hole near the 90° elbow position is higher. This study contributes to the understanding of steam condensation dynamics in pressure-relief tanks. When the steam emission and pressure are fixed, the equilibrium temperature increases linearly as the initial temperature increases (where a = 1, b = 20 in y = a x+ b correlation), the equilibrium pressure increases nearly exponentially, and the equilibrium gas volume decreases. When the steam emission and initial temperature are fixed, the equilibrium temperature does not change as the steam discharge pressure increases. The correlations between the predicted equilibrium parameters and the inlet steam parameters and tank temperature provide valuable insights for optimizing a pressure-relief tank design and improving the operational safety in diverse industrial contexts.

ICONE23-1322 CFD SIMULATION OF DIRECT CONTACT CONDENSATION PHENOMENON OF VAPOR IN SUBCOOLED WATER TANK

CFD Simulation of Direct Contact Condensation Phenomenon of Vapor Jet in Subcooled Water Tank

Computational Fluid Dynamics Simulation Of Direct-Contact Condensation Phenomenon Of Vapor Jet In Subcooled Water Tank

NUMERICAL INVESTIGATION ON DIRECT CONTACT CONDENSATION CHARACTERISTICS OF STEAM INJECTION INTO COLD-WATER PIPE UNDER HEAVING CONDITION

Numerical Study on Direct-Contact Condensation of Vapor in Cold Water

ICONE19-43732 NUMERICAL SIMULATION ON BUBBLE DEPARTURE FROM HEATED SURFACE IN SUBCOOLED POOL BOILING

Entropy Assessment on Direct Contact Condensation of Subsonic Steam Jets in a Water Tank Through Numerical Investigation

Direct Contact Condensation Characteristics of Steam Injection into Cold-Water Pipe Under Rolling Condition

Study of Condensation during Direct Contact between Steam and Water in Pressure-Relief Tank

Analysis of wave influence on steam condensation with non-condensable gases using cfd

Experimental study on heat transfer characteristics of steam underwater direct-contact condensation

Experimental Study on the Direct Contact Condensation of Steam Jet in Subcooled Water Flow in a Rectangular Mix Chamber

Experimental investigation on two-phase flow instability induced by direct contact condensation in open natural circulation

ICONE23-1996 CFD SIMULATIONS OF THERMAL MIXING AT ECC SAFETY INJECTION FOR SINGLE PHASE AND AIR-WATER BUBBLY PHASE FLOW

Inundation Correlation Research on the Simulation of Two-Phase Flow and Heat Transfer in a Condenser

ICONE15-10542 APPLICATION OF INTERFACE TRACKING METHOD TO INVESTIGATE SOME PHENOMENA INVOLVED IN FUEL-COOLANT INTERACTIONS

Experimental Study on the Effect of Non-Condensable Gas Dissolved in Sub-Cooled Water on Steam Jet Condensation in a Rectangular Channel

Numerical Research on Thermal Mixing Characteristics in a 45-Degree T-junction for Two-Phase Stratified Flow During the Emergency Core Cooling Safety Injection

Numerical study on the condensation characteristics of vapor with non-condensable gas on inclined walls inside containment

CFD simulation of water vapour condensation in the presence of non-condensable gas in vertical cylindrical condensers

Numerical investigation on direct contact condensation-induced water hammer in passive natural circulation system for offshore applications