Abstract:Particle holdup and the average residence time in the cyclone of a Circulating Fluidized Bed (CFB) boiler are important information for describing events post-combustion in the cyclone that often lead to a noticeable increase in the temperature of the flue gas. The existing results for the variation of particle average residence time with fluidizing gas velocity are contradictory since they were obtained under different operation conditions. A cold CFB apparatus made of plexiglass was established with a riser of 5 m in height and 0.2 m in diameter and equipped with a standard Lapple cyclone. The particle holdup was directly measured by the mass in the cyclone when the system was shut down. The solid concentration at the cyclone inlet was kept in the range generally used in CFB boilers. The experimental results showed that the particle holdup in the cyclone was equal to ca. 10-40% of the corresponding bed material in the riser and that it increases monotonously with both the fluidizing gas velocity and the initial static bed height, and approximately linearly with the solid circulation rate. In addition, within the experimental conditions, the cyclone pressure drop increases monotonously with particle holdup. It was found that the average residence time of the particles either increased or decreased linearly with the fluidizing gas velocity, depending on the initial static bed height. Nevertheless, both variation rates were very small. In a view of engineering applications, the average residence time of the particles in the cyclone is insignificantly affected by the fluidizing gas velocity, initial bed inventory and solid circulation rate, within the range of experimental conditions examined.

K-1413 Experimental Study on Characteristic of Particles at Exit Zone in CFBB by PTV

Particle Velocity Measurements in Transition Section of Turbulent Fluidized Beds Using Optical Fiber Probe and CFD Simulation

Particle Decelerating Regions in Turbulent Fluidized Bed

Visual Measurement of Particle Movement in Rectangular Circulating Fluidized Bed

Investigation to Gas-Particle Two-Phase Flow in CFB using PTV Technology

A Study of the Transverse Dispersion of Solid Particles in the Dense-phase Zone of a Circulating Fluidized Bed Boiler

Experimental Investigation on Local Particle Volume Fractions Distribution in Offset-Exit Circulating Fluidized Bed

Effect of Exit Structure on the Particle Velocity Distribution in the Dilute Region of a Rectangular Circulating Fluidized Bed Riser

Particle Residence Time Distribution in a Circulating Fluidized Bed

Particle Holdup And Average Residence Time In The Cyclone Of A Cfb Boiler

Effect of clusters on the gas solid flow field in the circulating fluidized bed by PIV

PIV measurement of the gas-solid flow pattern in a CFB riser

Experimental study of two-phase flow inside finned-tubes separator using 3-D-PDA

Particle holdup and average residence time in the cyclone of a circulating fluidized bed boiler

Experimental Research on Flow Field of Coal-water Slurry High Temperature Flue Gas Particle with Particle Image Velocimetry

Effect of Riser Geometry Structure on Local Flow Pattern in a Rectangular Circulating Fluidized Bed

Experimental Study on the Heat Transfer Coefficient Between A Freely Moving Sphere and A Fluidized Bed of Small Particles

Lateral and Axial Mixing of the Dispersed Particles in CFB.

Characteristic-particle-tracked Modeling for CFB Boiler: Coal Combustion and Ultra-Low NO Emission

Particle-Scale Investigation of Heat Transfer and Erosion Characteristics in a Three-Dimensional Circulating Fluidized Bed

Measurement of Characteristics of Solid Flow in the Cyclone Separators with Fiber Optical Probe